KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第278页

4 – 171 The f ollowing window displays after a station is select ed: Figure 4.10.3. 2 Nozzle Layout Displ ay Example • Perm. Nozzle (Permanent nozzle): Nozzle lay out which is set on the Machine setup menu. ( * mark indi…

4 – 170

Figure 4.10.2.3 Divided Placement Data Display Example (Optimization Order)

Note: When displayed in optimization order, the pair end mark “/” indicates the

separation of data paired during one pick and placement cycle of operation.

4.10.3



 Nozzle layout

This command displays the nozzles assigned to each station by the Optimization

utility.

Figure 4.10.3.1 Nozzle Layout Selection

Select the “Nozzle Layout” menu command from “Optimization” menu. The sub-menu

appears which allows you to select a station. Select the desired station on this

sub-menu.

Notes:

①

This menu cannot be selected if optimization has not been preformed or

if the production program has been changed after optimization.

②

Nozzle displayed here are nozzles that are set in the Machine setup

menu and nozzle used in the program data.

4 – 171

The following window displays after a station is selected:

Figure 4.10.3.2 Nozzle Layout Display Example

• Perm. Nozzle (Permanent nozzle):

Nozzle layout which is set on the Machine setup menu.

( * mark indicates the vacuum calibration.)

• Opt. Nozzle (Optimized nozzle):

Nozzle layout which is output with the Optimization utility.

( * mark indicates the vacuum calibration.)

• No. of Nozzles:

Number of nozzle resources (Resource), the number of nozzles set as

the permanent information (Perm. Info) and the number of nozzles output

with the Optimization utility (Opt.) are displayed here.

• Close: Quits the Nozzle layout dialog box.

Enabled for

KE-2030 onl

4 – 172

4.10.4



 Component supply count

Specify the number of components to be supplied which can be assigned by the

Optimization utility. By using two or more components (reel or tray), the productivity

can be improved.

Figure 4.10.4.1 Component supply count command

When the [Component supply count] menu command is selected, the following dialog

box displays:

Figure 4.10.4.2 Component supply count dialog box example

The detailed descriptions of each item displayed on the Component supply count

dialog box are shown below:

Figure 4.10.4.3 Component supply count dialog box details

Component name

included in the

program

Displays the number of feeders output

by the Optimization utility or the

number of feeders manually assigned

Indicates that the Optimaization

utility is to set the number of

feeders automatically.

When specified manually, it

displays “—“