KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第292页
4 – 185 W hen y ou select a f eeder on t he left station, it is copied to the r ight st ation, while w hen you select a f eeder on the rig ht station, it is copied to the left station. In both cases, t he selected f eede…
4 – 184
Figure 4.11.1.16 Feeder copy error message
Note: If you select a feeder lying astride the front and rear sides, the system cannot
copy it.
7. Cop to left or right (This function is available only with a KE-2030 station.)
This command copies the selected feeder to the left station or right station
(This function is available only with a KE-2030 station.).
While dragging the trackball to enclose the feeder which is to be copied to
highlight it, press the right button of the trackball. The pop-up menu appears
on the screen. Select the [Copy to left or right] command.
Figure 4.11.1.17 Pop-up menu
4 – 185
When you select a feeder on the left station, it is copied to the right station,
while when you select a feeder on the right station, it is copied to the left station.
In both cases, the selected feeder is copied onto the same hole position of the
opposite station.
[Copy to left or right] command is executed.
Figure 4.11.1.18 Copy operation with the [Copy to left or right] command
Notes:
•
When you use a station other than a KE-2030, this menu item is displayed
in gray and you cannot select it.
•
A permanent component or tray component cannot be copied.
•
If you select a feeder lying astride the left station and right station, the
system cannot copy it.
•
If any component was already assigned to the copy destination, the error
message shown in Figure 4.11.1.16 appears on the screen, and the system
does not copy the feeder.
4 – 186
4.12 Machine Operation
This command actually operates the main unit to take various actions. The Machine
operation menu provides menu items corresponding to each action.
The table below describes the sub menu corresponding to each menu item and
outlines its function.
Menu item Sub menu 1 Sub menu 2 Outline of function
PWB load
PWB eject
Loads or ejects a PWB into/from the main unit. Transport
Auto conveyor Adjusts the width of a PWB.
Current
component
Measurement
All component
Measures a component according to the settings of
Component data in details.
Vision
recognition
Inspects whether vision recognition is available. Inspection
Coplanarity
inspection
Performs a coplanarity check and obtains the
corresponding parameter.
BOC Confirms a BOC mark recognition operation and
saves the measured values.
Mark
Feeder Bank
(Front/Rear)
Confirms a bank mark recognition operation and
saves the measured values.
Place tracking Checks a position specified with each set of
coordinates of Placement data.
Pick tracking Checks a position specified with each set of
coordinates of Pick data.
Confirmation
Coordinate
Height tracking Checks each height specified in Pick data.
Management Management Mark Database Performs various operations of the mark database.