KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第43页
1 − 26 1.2.3 Component feeder Totally two component f eeder bank s are provided: one bank is located at t he fr ont and rear of the PW B transport unit respectively. The com ponent supply method varies depending on the p…
1 − 25
Figure 1.2.2.1
①
IN sensor
⑨
Stopper
②
OUT sensor
⑩
Pusher X (Edge reference option)
③
STOP sensor
⑪
Centering pin
④
C-OUT sensor
⑫
BU table
⑤
BU-UP sensor
⑬
Motor control
⑥
BU-DOWN sensor
⑭
BU pin
⑦
PWB transport motor
⑮
Pusher Y (Edge reference option)
⑧
Drive shaft
⑯
Wait sensor
①
⑦
⑯
⑬
⑩
⑪
③
⑨
⑪
④
②
⑧
⑧
⑭
⑮
⑫
⑤
⑥
⑧
1 − 26
1.2.3 Component feeder
Totally two component feeder banks are provided: one bank is located at the front
and rear of the PWB transport unit respectively. The component supply method
varies depending on the package style of components: tape, bulk, stick or tray.
Components fed by a tape (chip components) or those fed in a stick are mounted on
the feeder bank with using a tape feeder, bulk feeder, stick feeder or stacked stick
feeder, then carried in the main unit. A tray component is fed from a tray holder,
matrix tray changer, or matrix tray server. A tray holder, matrix tray changer or
matrix tray server.can be mounted on the rear of the machine.
When using an overall feeder exchange trolley (option), the feeder bank can be
removed from the main unit of this machine for preparation.
(
)
Figure 1.2.3.1
Feeder banks
PWB
Vision monitor
Rear
Front
PWB transport unit
1 − 27
1. Feeder bank parts identification (See Figure 1.2.3.2.)
The tape feeder loaded with taped components, stick feeder loaded with
components in sticks bulk feeder loaded with components in bulk are positioned
and secured by the fixing plate ②, and lock shaft ④.
The component feeding device is driven by the drive cylinders ⑤.
The position label ⑥ is used to determine the position at which each feeder is
installed. You can see LED status of the FPI (optional) to decide where to set
each feeder.
The bank mark ⑦ is the mark for correcting the position of the feeder set.
6
2
4
1
5
7
3
① Feeder bank ⑤ Drive cylinder
② Fixing plate ⑥ Position label
③ Fixing plate B ⑦ Bank mark
④ Lock shaft
Figure 1.2.3.2