KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第558页
7 − 21 7.2.2.3 Ref erence pin positi on A screen appears as shown in Figure 7.2. 2.3.1 “ Reference pin posit ion setting dialog box” when [Reference pin posit ion] is selected f rom the [Sett ing Gr oup] menu. Figure 7.2…
7 − 20
CAUTION
When you click the <DONE> button, the head moves to allow you to
attach/detach a nozzle.
To avoid a risk of injury, do not place your hand in the machine, nor
move your face or head close to the machine.
Before clicking the <DONE> button, check to see if there is no one who
is working in the machine.
Before clicking the <DONE> button, check to see if there is no one who
can be injured around the machine.
Before clicking the <DONE> button, check to see if there is no obstacle
(tool or jig) left or attached in the machine.
7 − 21
7.2.2.3 Reference pin position
A screen appears as shown in Figure 7.2.2.3.1 “Reference pin position setting
dialog box” when [Reference pin position] is selected from the [Setting Group]
menu.
Figure 7.2.2.3.1 Reference pin position setting dialog box
(1) Setting items
No. Item Description
1 Reference pin (X, Y) Reference pin position
2 Follower pin (X, Y) Follower pin position
3 Ref. pin adjust Board filting angle calculated based on the positions of the reference pin and
the follower pin (for automatic operation only)
(2) How to set
− Key in X and Y coordinate values directly from the keyboard.
− Use the HOD to teach and enter the coordinates. In this case, both the X
and Y values are entered at the same time if either X or Y is in focus.
When the X or Y of the reference pin is in focus, the values will be used for
the reference pin. When t-he X or Y of the follower pin is in focus, the
values will be used for the follower pin.
− Follow the procedure below to raise the support plate before teaching.
7 − 22
− Press the F9 key or click the right button of the track ball to start up the
Mechanical Setup window. Then, set the “Support plate” to ON.
Figure 7.2.2.3.2
− During teaching, the following “Question” message appears on the screen.
Figure 7.2.2.3.3
− When the support plate is raised, click the <Yes> button.
CAUTION
To avoid a risk of injury, do not place your hand in the machine, nor
move your face or head close to the machine during operation of the
HOD.
If you are to produce PWBs based on the reference pin, be sure to
check the setting of the item "Reference pin" above. If the reference
pin is not set before a PWB is fed, the "Reference pin error" is
displayed on the screen.