KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第560页
7 − 23 7.2.2.4 Shape cl amp position A screen appears as shown in Figure 7.2. 2.4.1 “ Shape clamp position sett ing dialog box” when [Shape clamp position] is selected f rom t he [Setting Group] menu. Figure 7.2.2. 4.1 S…
7 − 22
− Press the F9 key or click the right button of the track ball to start up the
Mechanical Setup window. Then, set the “Support plate” to ON.
Figure 7.2.2.3.2
− During teaching, the following “Question” message appears on the screen.
Figure 7.2.2.3.3
− When the support plate is raised, click the <Yes> button.
CAUTION
To avoid a risk of injury, do not place your hand in the machine, nor
move your face or head close to the machine during operation of the
HOD.
If you are to produce PWBs based on the reference pin, be sure to
check the setting of the item "Reference pin" above. If the reference
pin is not set before a PWB is fed, the "Reference pin error" is
displayed on the screen.
7 − 23
7.2.2.4 Shape clamp position
A screen appears as shown in Figure 7.2.2.4.1 “Shape clamp position setting dialog
box” when [Shape clamp position] is selected from the [Setting Group] menu.
Figure 7.2.2.4.1 Shape clamp position setting dialog box
(1) Setting items
No. Item Description
1 X Stopper pin position
2 Y Reference board transport rail position
(2) Setting the position
− Key in X and Y coordinate value directly from the keyboard.
− Use the HOD to teach and enter the coordinates for X and Y separately. In
this case, if X is in focus, only X is taught, then stored.
− To teach Y, Y shall be in focus.
CAUTION
To avoid a risk of injury, do not place your hand in the machine, nor
move your face or head close to the machine during operation of the
HOD.
7 − 24
7.2.2.5 MTC shuttle pick position
When you select the [MTC shuttle pick position] command, the "MTC shuttle pick
position setting" dialog box appears on the screen as shown in Figure 7.2.2.5.1.
Figure 7.2.2.5.1 MTC shuttle pick position setting dialog box
(1) Setting items
No. Item Description
1 MTC shuttle pick position (X, Y, Z) Component pick-up position on the MTC shuttle
(2) Setting the position
- Key in X, Y and Z coordinate values directly from the keyboard.
- Use the HOD to teach and enter the coordinates. In this case, if the input
focus is located in any of the X, Y and Z fields, all of the values are taught,
then entered.
- To teach the Z coordinate, the input focus should be located in the “Z” field.
Even though the input focus is located in any of the Z fields, the values are
all taught, then entered to the “Large”, “Small” and “Clamp” items.
- When you select the device key of the HOD, the following message appears
on the screen. When you click the <Yes> button, a shuttle is pulled out
from an MTC.
Figure 7.2.2.5.2 “Question” dialog box