KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第667页
9 − 13 9.4.2.3 Set ting the w arning level W hen y ou select t he [Tool] command on the m enu bar, t he [The W arning level is set] command on the displayed menu, t hen the [Each nozzle] Command the scr een appears as sh…
9 − 12
− The "Exchange frequency setup dialog box" above allows you to select data to be
reset with a keyboard or mouse, then select the [Reset] on the pop-up menu
which is displayed by your clicking the right button to reset the selected data.
- When you click the <Reset> button displayed on the bottom of the dialog box
above, the system allows you to reset data also, then the following dialog box
appears on the screen.
Figure 9.4.2.2.3 Frequency resetting confirmation dialog box
- When you click the <OK> button, the selected data is reset. When you click the
<Cancel> button, the system does not reset the selected data.
When you click the [All Reset] on the pop-up menu shown in Figure 9.4.2.2.2, the
following dialog box appears on the screen.
Figure 9.4.2.2.4 All frequency data resetting confirmation dialog box
- When you click the <OK> button on the dialog box above, the system resets all of
the operation information of each nozzle. When you click the <Cancel> button,
the system does not reset any data.
9 − 13
9.4.2.3 Setting the warning level
When you select the [Tool] command on the menu bar, the [The Warning level is set]
command on the displayed menu, then the [Each nozzle] Command the screen
appears as shown in Figure 9.4.2.3.1.
Figure 9.4.2.3.1 <Warning level is set> dialog box
− If the number of times components were picked up actually exceeds the warning
level you set here, the nozzle is displayed in yellow on the "Operation Information
of each nozzle" screen shown in Figure 9.4.2.1.1.
The signal lights lighting condition remains unchanged.
9 − 14
9.4.2.4 Setting the error level
When you select the [Tool] command on the menu bar, the [The Error level is set]
command on the displayed menu, then the [Each nozzle] command, the screen
appears as shown in Figure 9.4.2.4.1.
This screen allows you to set the error level.
Figure 9.4.2.4.1 "The error level is set" dialog box
− If the number of times components were picked up actually exceeds the error
level you set here, the nozzle is displayed in red on the "Operation Information of
each nozzle" screen shown in Figure 9.4.2.1.1.
The signal lights lighting condition remains unchanged.