KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第702页
10 − 18 (2) How to se t − Follow the instructions displayed to set the VCS select ed in the “Select VCS” combo box. − W hen you click t he <OK> butt on, your setting becomes valid (but not saved at this point). − W…
10 − 17
10.7 VCS Binary-Coded Threshold (Not Available with a KE-2010)
When you select the [Binary threshold for VCS] command on the “Set-up group”
command menu, the following “Binary threshold for VCS” dialog box appears on the
screen.
Figure 10.7.1 “Binary threshold for VCS” dialog box
− Select VCS
Using this combo box, select the VCS to be set.
You cannot select any unit which is not checked on the “Device enable” menu
invoked from the Machine Setup menu (that is, checked as “Not used”).
When you press the Alt key and the down arrow key at the same time, the
following list appears on the screen.
(1) Setting item
No. Item Description
1 Binary threshold Binary-coded threshold (threshold level) when recognized by the VCS
(Threshold already set)
(Threshold measured)
10 − 18
(2) How to set
− Follow the instructions displayed to set the VCS selected in the “Select VCS”
combo box.
− When you click the <OK> button, your setting becomes valid (but not saved at
this point).
− When you click the <CANCEL> button, you setting becomes invalid.
− How to operation
Follow the instructions displayed to obtain the appropriate value automatically.
(When the right standard VCS is selected)
The machine sets up the VCS selected in the “Select VCS” combo box.
Select the <Exec.> button.
When you select the <Exec.> button, the machine measures a binary-coded
threshold after mounting the No. 508 nozzle to move it on the selected VCS
camera.
− Measurement operation
① Attach the No. 508 nozzle onto the FMLA head.
An error occurs if the nozzle is set for the ATC. In this case, assign the
nozzle on the “ATC nozzle setup” menu invoked from the Machine Setup
menu.
② Move the FMLA head to the position where the selected VCS camera
recognizes.
③ The machine uses the selected VCS to measure a binary-coded
threshold.
10 − 19
(When the right standard VCS is selected)
The machine has finished measurement operation.
To repeat the measurement operation, select the <Exec.> button.
When you select the <Exec.> button, the previous screen reappears.
To measure another VCS, select the desired VCS in the “Select VCS” combo
box.
When you change the VCS to be set in the “Select VCS” combo box, the
initial screen appears.
To quit Self-calibration mode, select the <OK> button.