KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第763页

13 − 7 13.2.4 A ir filter (Head) 1) Loosen the scr ew ② f ixing the Z slide shaf t ① t o pull out the nozzle outer shaf t ③ . 2) Check to see if ther e is any contamination of the f ilter ④ . 3) I f any, r emove the f il…

13 − 6

(2) Piping diagram (Head)

Blow-Sw

ø8

(3) Piping diagram (Overall changer table, Common to all four tables)

ø6

Ejector

Filter

Pressure sensor

Nozzle

Roller lever

Selector

Pilot check valve

13 − 7

13.2.4 Air filter (Head)

1) Loosen the screw ② fixing the Z slide shaft ① to pull out the nozzle outer shaft

③.

2) Check to see if there is any contamination of the filter ④.

3) If any, remove the filter ④ from the nozzle outer shaft, the replace it with a new

one.

4) Push the nozzle outer shaft ③ into the Z slide shaft ①, then fix it with the screw

②.

Filter ④: Part number E3052729000

WARNING

To prevent the body from injury which can be caused by accidental

activation of the machine, turn off the power of the machine before

following the operation above.

④

③

②

①

13 − 8

13.2.5 Air filter (CAL block)

Check the element of the air filter (CAL block) for dirt. If the element is dirty, detach

the air tube and replace the filter with a new air filter (Part No. PF010001000).

Note: Install the air filter with its hole (part A) facing up.

WARNING

To prevent the body from injury which can be caused by accidental

activation of the machine, turn off the power of the machine before

following the operation above.

Air tube

Part A