KE2010.Instruction Manual.Ver.2.01,Rev.08 - 第785页

13 − 29 13.4.6 Backup table Apply grease to the ent ire surf ace of each shaft of t here ball screws mark ed with *.   WA RNING To prevent t he body from injury which can be caused by accidental activation of the machi…

13 − 28

13.4.5 Ball screws and Linear way (Head part)

Apply a light coating of grease (C grease) to the ball screws and the linear way rails.

Apply a light coating of grease (C grease) to the spline shaft axis.

After applied the grease, move the Z axis by hand for the grease to be fit.

After fitting grease to the spline shaft axis sufficiently, remove extra grease with cloth

or similar matter so that it cannot be splattered.

① Ball screws

② Linear way

③ Spline shaft

Notes: Never apply any grease other than C grease to the parts above.

When C grease is mixed with another type of grease, it may be separated from

the screw, rails or shaft and run down.

WARNING

To prevent the body from injury which can be caused by accidental

activation of the machine, cut off the power to the machine before

starting to work.

①

②

③

13 − 29

13.4.6 Backup table

Apply grease to the entire surface of each shaft of there ball screws marked with *.





WARNING

To prevent the body from injury which can be caused by accidental

activation of the machine, cut off the power to the machine before

starting to work.

13.4.7 Movable board transport table ball screw and LM guide

Note: Never apply any grease other than C grease to the parts above.

WARNING

To prevent the body from injury which can be caused by accidental

activation of the machine, cut off the power to the machine before

starting to work.

Grease (Cgrease)

13 − 30

13.4.8 Overall feeder exchange trolley (optional)

Apply grease to the bank locating pin ① and guide shaft ②.



① Bank locating pin

② Guide shaft