00193348-01 - 第18页

Instructions for changing catch on component feeder table HS-50 11/2001 Issue 18 : Attach the mounting bracket with the Schm ersal sw itch with two screws and washer s. 2 Rem ember t o en sure t hat t he f irst t wo sc r…

Instructions for changing catch on component feeder table HS-50

11/2001 Issue

: Remove the plug connector for the component feeder table catch, and then remove the snap-

action switch and cable.

: Attach the new connector and feed the cable round the corner of the placement machine.

: Fix the mounting plate to the side wall using a screw and a washer.

Remember to pay special attention to left and right mounting when attaching the plate. 2

. 2

Instructions for changing catch on component feeder table HS-50

11/2001 Issue

: Attach the mounting bracket with the Schmersal switch with two screws and washers.

Remember to ensure that the first two screws are screwed into the oval holes before you fix the

plate in place and tighten the screws. 2

: Mount the gas springs by fitting them into the appropriate mounting at each end and fix using

the securing clips.

: Close the catch of the component feeder table

Note:

Left-mounted variant

Instructions for changing catch on component feeder table HS-50

11/2001 Issue

: Push the switch of the component feeder table catch into place.

: Mountthesidewallontothemachineandscrewitintoplace.

: Close the protective hood.