00193790-01 - 第121页
Installation and Getting Started with CACCIA 2 English Issue 07/2004 2.10 O verview of the J umper Settings for Individual Subsystems 55 2.10.3.5 T win Head Main Board The mai n board i s mounted directl y on the t op of…
2 English Installation and Getting StartedwithCACCIA
2.10 Overview of the Jumper Settings for Individual Subsystems Issue 07/2004
54
2.10.3.4 Head Adapter Twin Head
Theheadadapter board connects theheadinterface board directly to the mainboardof Twinhead
segment 1 and 2 via ribbon cable. This head adapter must be changed for head modularity, if you
use a C&P head.
Fig. 2 - 44 Head adapter Twin head
Legend
(1) Connector Z-Axis Twin head 1
(2) Connector D-Axis Twin head 1
(3) Connector DP-Axis Twin head 2
(4) Connector Z-Axis Twin head 2
(5) PP1 Boot CAN Processor Twin Segm. 1
(6) PP1 Reset CAN Processor Twin Segm. 1
(7) PP2 Boot CAN Processor Twin Segm. 2
(8) PP2 Reset CAN Processor Twin Segm. 2
1
24
3
OFF
1
4
5
6
7
8
Installation and Getting Started with CACCIA 2 English
Issue 07/2004 2.10 Overview of the Jumper Settings for Individual Subsystems
55
2.10.3.5 Twin Head Main Board
The main board is mounted directly on the top of the frame of the Twin head. This board is
connected to the head adapter via ribbon cable (one ribbon cable for each axis).
Fig. 2 - 45 Main board Twin head
1
2
3
4
6
5
7
8
9
2 English Installation and Getting StartedwithCACCIA
2.10 Overview of the Jumper Settings for Individual Subsystems Issue 07/2004
56
Legend
(1) Connector for the 16BitCAN Bus Processor (Control the analog or digitalvacuum generator)
(2) LED´S (Description from top to bottom)
-D6BEROZ-axis top (not used)
- D1 not defined
-D2ClampingZ-axis (yellow) LED off, retract unit is at top position.
- D15 Temperature monitoring Z-axis linear motor (red) LED on, is ok.
(3) Connectors to the head adapter
(4) Connector track signals Z-axis
(5) Connector BERO Z-axis (not used)
(6) Connector pneumatic valve (retract unit)
(7) LED‘s: D7 - is ON after reference run
D8 - protect Z-axis without function
D9 - without function
D10 - green LED ON 24Vfor the vacuum generator
D14 - Alarm output for the vacuum generator (red LED ON vacuum generator defect)
(8) Connector for valve (only 24 Volts on pin 2 and 4 measured)
(9) Hole for pneumatic pipe to the vacuum generator