196396 Iss 2 Nov 2015 - Semi Appendix Manual - 第111页

PREVENTIVE MAINTENANCE MONTHLY MAINTENANCE 28.50 Technical Reference Manual Chapter Issue 5, Aug 14 Estimated time req uired for Monthly tasks 4.0 hours Summary/Remarks Signed: Date:

100%1 / 140
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
Chapter Issue 5, Aug 14 Technical Reference Manual 28.49
Monthly Hardware Check
SEMI Level M27 HTC Enclosure Tick
Inspect wiring and connections.
Clean area around air inlet.
SEMI Level M36 Control Enclosure Tick
Inspect wiring and connections.
Ensure cards are seated properly.
Clean area around air inlets.
SEMI Level M37 Power Supply Enclosure Tick
Inspect wiring and connections.
Clean area around air inlet.
SEMI Level M39 Emergency Machine Off Enclosure Tick
Inspect wiring and connections.
SEMI Level PC Enclosure Tick
Inspect wiring and connections.
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
28.50 Technical Reference Manual Chapter Issue 5, Aug 14
Estimated time required for Monthly tasks 4.0 hours
Summary/Remarks
Signed: Date:
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
Chapter Issue 5, Aug 14 Technical Reference Manual 28.51
Month November Maintenance Procedure
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
WARNING
HARMFUL SUBSTANCES. CLEANING WIPES AND CLEANING SOLUTIONS MAY
CONTAIN SUBSTANCES HAZARDOUS TO HEALTH. OBSERVE ALL
MANUFACTURERS’ HEALTH AND SAFETY GUIDELINES. ALWAYS WEAR
APPROVED PROTECTIVE CLOTHING WHEN CLEANING THE MACHINE.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. SAFETY GLOVES MUST BE WORN.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. EYE PROTECTION MUST BE WORN.
SPC Alignment
Check and Machine
Cycle Count
Fill out details: SPC Alignment Check and Machine Cycle Count at the start of
this section.
Software
SEMI Level Software Check Record Tick
Check the date and time settings.
Check the software loaded and options.
Check the software version is the latest issue.
SEMI Level View Event Log Tick
Check for initialisation errors.
Check for screen position errors (31210, 31211, 31212).
Check for camera errors (31207, 31208).