196396 Iss 2 Nov 2015 - Semi Appendix Manual - 第78页

PREVENTIVE MAINTENANCE MONTHLY MAINTENANCE Chapter Issue 5, Aug 14 Technical Reference Manual 28.17 SEMI Level M39 Emergency Machine Off En closure Tick Inspect wiring and connections. SEM I1 SEMI Level PC Enclosure Tick…

100%1 / 140
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
28.16 Technical Reference Manual Chapter Issue 5, Aug 14
Monthly Hardware Check
SEMI Level Machine Safety Tick
Examine the condition of the mains input lead.
Check all earth leads and bonding points are connected.
Check operation of the cover interlock.
Check operation of the Emergency Machine Off button.
Toggle all beacon lights.
SEMI Level Pneumatics Tick
Check air pressure switch is set to 3 bar.
Check the air inlet regulator is set to 4.5 bar. (5.0bar if TRS option fitted).
Check pipes for air leaks.
Check and empty the air line water trap.
SEMI Level M27 HTC Enclosure Tick
Inspect wiring and connections.
Clean area around air inlet.
SEMI Level M36 Control Enclosure Tick
Inspect wiring and connections.
Ensure cards are seated properly.
Clean area around air inlets.
SEMI Level M37 Power Supply Enclosure Tick
Inspect wiring and connections.
Clean area around air inlet.
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
Chapter Issue 5, Aug 14 Technical Reference Manual 28.17
SEMI Level M39 Emergency Machine Off Enclosure Tick
Inspect wiring and connections.
SEMI Level PC Enclosure Tick
Inspect wiring and connections.
SEMI Level TRS Pull Down Reference Fork Grooves Tick
Inspect for wear, clean and apply a small amount of grease around the brace assembly
fork groove and underneath the fork base.
Important:
Cycle the system a few times to check the active distribution of the grease.
Remove any displaced grease (in areas where it wasn’t originally applied) from
the forks and cap.
Estimated time required for Monthly tasks 4.0 hours
Summary/Remarks
Signed: Date:
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
28.18 Technical Reference Manual Chapter Issue 5, Aug 14
Month February Maintenance Procedure
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
WARNING
HARMFUL SUBSTANCES. CLEANING WIPES AND CLEANING SOLUTIONS MAY
CONTAIN SUBSTANCES HAZARDOUS TO HEALTH. OBSERVE ALL
MANUFACTURERS’ HEALTH AND SAFETY GUIDELINES. ALWAYS WEAR
APPROVED PROTECTIVE CLOTHING WHEN CLEANING THE MACHINE.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. SAFETY GLOVES MUST BE WORN.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. EYE PROTECTION MUST BE WORN.
SPC Alignment
Check and Machine
Cycle Count
Fill out details: SPC Alignment Check and Machine Cycle Count at the start of
this section.
Software
SEMI Level Software Check Record Tick
Check the date and time settings.
Check the software loaded and options.
Check the software version is the latest issue.
SEMI Level View Event Log Tick
Check for initialisation errors.
Check for screen position errors (31210, 31211, 31212).
Check for camera errors (31207, 31208).