00194440-10_SM_X-Series_Customer_en - 第182页
Service Work Modular PCB Conveyor System 3.6.16 Mapping 182 Service Manua l SIPLACE X Series ► You will now be asked to ins ert the calibration tool. ► The nozzle required for component mapping needs to be set up on all …
Service Work
3.6.16 Mapping Modular PCB Conveyor System
Service Manual SIPLACE X Series 181
► Select the Conveyor .
► Select the Mapping plate width as 300 mm.
► If you only have one mapping plate available, select
Process jobs in PA1 first and then in PA2.
If you have two mapping plates available, select Pro-
cess jobs in parallel in both processing areas.
► Start the mapping procedure.
You will now be asked to prepare the placement are-
as.
Service Work
Modular PCB Conveyor System 3.6.16 Mapping
182 Service Manual SIPLACE X Series
► You will now be asked to insert the calibration tool.
► The nozzle required for component mapping needs to
be set up on all heads.
If this is not the case, you will be asked to change the
nozzle accordingly.
► Read in the correction data.
CAUTION
► When you insert the mapping plate into the conveyor, always make sure that there are no
obstacles (e.g. board supports) on the conveyor lifting table!
► If options are fitted in the conveyor, always check first whether these could cause problems
for the mapping process, otherwise these might damage the mapping plate.
► Once the data is loaded, you will be asked to place
the mapping plate into the input conveyor.
Service Work
3.6.17 Replacing the Conveyor Conversion Board Modular PCB Conveyor System
Service Manual SIPLACE X Series 183
3.6.17
3.6.17 Replacing the Conveyor Conversion Board
Replacing the Conveyor Conversion Board
Parts
The conversion board needed varies according to the conveyor type.
▪ Conveyor Conversion Board (Single and Dual Conveyor) [00359425-xx]
▪ Conveyor Conversion Board (Quad Lane Conveyor) [03066716-xx]
Overview
Removal
► Move the conveyor apart so that you can easily access the working area.
► Switch off the machine.
► Dismantle the cover (2).
► Mark all connections on the conversion board, so that these can be easily allocated again later on.
► Loosen all connections on the conversion board.
► Remove the conversion board from the machine.
Installation
► Fit the new conversion board in the reverse order.
► Then perform a function test.
See also
3.6.22.3 Conveyor Conversion Board (Quad Lane Conveyor) [03066716-xx] [ ➙ 192]
1. Conveyor conversion board
(for single and dual conveyor here)
2. Cover
The conveyor conversion board (1) is situated in place-
ment area 1 underneath the Y axis, in the vicinity of the
intermediate conveyor, under the cover (2).
1
2