00194440-10_SM_X-Series_Customer_en - 第252页

Measuring Equipmen t and Tools Programming Cable for PXS240 Sensor [03073330-xx] 4.1.1 Scope of Delivery 252 Service Manua l SIPLACE X Series 4.12 4 . 1 2 P r o g r a m m in g C a b le f o r P X S 2 4 0 S e n s o r [ 0 3…

100%1 / 384
Measuring Equipment and Tools
4.1.1 Scope of Delivery Calibration Tool [03010565-xx]
Service Manual SIPLACE X Series 251
4.9
4.9 Calibration Tool [03010565-xx]
Calibration Tool [03010565-xx]
4.10
4.10 Calibration Tool [03034148-xx]
Calibration Tool [03034148-xx]
4.11
4.11 Calibration Nozzle for TwinHead [03008862-xx]
Calibration Nozzle for TwinHead [03008862-xx]
Use:
The calibration tool [03010565-xx] is used for calibration
of the DLM, CPP, P&P heads, TwinHead and PCB cam-
era.
Use:
The calibration tool is used for the following placement
heads:
▪ C&P20
▪ C&P20 A
▪ C&P20 M
▪ C&P20 P
▪ CPP (only at X4i S without stationary camera)
Use:
The calibration nozzle is used to calibrate the D axis of
the TwinHead or P&P head.
NOTICE!
This nozzle is no longer needed from SW705.03.
Measuring Equipment and Tools
Programming Cable for PXS240 Sensor [03073330-xx] 4.1.1 Scope of Delivery
252 Service Manual SIPLACE X Series
4.12
4.12 Programming Cable for PXS240 Sensor [03073330-xx]
Programming Cable for PXS240 Sensor [03073330-xx]
4.13
4.13 Setting Gauge for Sonar Sensors [03048764-xx]
Setting Gauge for Sonar Sensors [03048764-xx]
4.14
4.14 Gauge for Stopper Setting [03067221-xx]
Gauge for Stopper Setting [03067221-xx]
Version 1 – UB-PROG4-V31 (old PXS240)
Version 2 – UB-PROG2
Setting gauge for ultrasonic sensors [03048764-xx]
Stopper setting gauge for fitting the stopper unit on the
holding bracket
Measuring Equipment and Tools
4.1.1 Scope of Delivery Mapping Test Plate 520x300 mm [03067312‑xx]
Service Manual SIPLACE X Series 253
4.15
4.15 Mapping Test Plate 520x300 mm [03067312-xx]
Mapping Test Plate 520x300 mm [03067312-xx]
4.16
4.16 ACT Calibration Plate, Single Set, for Quad Lane [03073073-xx]
ACT Calibration Plate, Single Set, for Quad Lane [03073073-xx]
4.17
4.17 Setting Gauge for Board Clamping [00369202-01]
Setting Gauge for Board Clamping [00369202-01]
A special mapping plate with a width of 300 mm has been
developed for the quad lane machines. These machines
can only be mapped with this mapping plate, as the con-
veyor can not be set to a width of 450 mm.
ACT calibration plate, single set, for quad lane
[03073073-xx]
Setting gauge for board clamping [00369202-01]