YS100_Mainte_E - 第134页

5-4 4 Input Title 2.4 W-axis (Conveyor) W-axis lubrication points W-axis ball screw W-axis ball screw Hexagonal spline W-axis guide W-axis guide 53504-L1-00 Lubrication section Lubrication point Interval Procedure Guide …

5-3

Input Title

2.2 Y-axis

Y-axis lubrication points

Grease nipple

Grease nipples

(front and rear)

X-axis guideX-axis ball screw

53502-L1-00

Lubrication section Lubrication point Interval Procedure

Guide 4

Every 2 months

Grease gun : Standard nozzle (ø 10mm)

Ball screw 2 Grease gun : Flexible type nozzle (ø 14mm)

2.3 PU-axis

PU-axis lubrication points

Ball screw

Ball guide

53503-L1-10

Lubrication section Lubrication point Interval Procedure

Ball guide 2 (4 for twin type)

Every 2 months Apply grease by hand.

Ball screw 2 (4 for twin type)

5-4

Input Title

2.4 W-axis (Conveyor)

W-axis lubrication points

W-axis ball screw

Hexagonal spline

W-axis guide

53504-L1-00

Lubrication section Lubrication point Interval Procedure

Guide 2

Every 6 months Apply grease by hand.Ball screw 2

Hexagonal spline 1

5-5

Input Title

2.5 Z-axis (Spline shaft)

NOTE

Basically, the lubricating the spline shaft (Z-axis) is not required. However, the grease on the spline shaft surface is

removed by touching with hand or by sprinkling solvent. As a result, the spline shaft gets easily rusted. Apply the

speciﬁed grease (NSL) slightly for anti-rusting as needed.

Z-axis lubrication points

Z-axis spline shaft

(upper side)

Z-axis spline shaft (lower side)

Z-axis spline shaft (middle-)

53505-L1-10

Lubrication section Lubrication point Interval Procedure

Z-axis spline shaft 8 As needed Apply a thin coat of grease by hand.