00196430-0102-AI_Head_Reconfiguration_Kit_SX_CPP_en_de - 第61页
Installing the CPP Placement Head Preparing the Head for the Instal lation Height Assembly of the C PP Placement Head Assembly Instructions / Montageanleitung Head Reconfiguration K it CPP 61 Assembly o f the CPP Placeme…
Installing the CPP Placement Head
Disassembling the TwinHead Conversion of the Head Adapter
60 Assembly Instructions / Montageanleitung Head Reconfiguration Kit CPP
Fitting the HCU onto the base adapter for CPP and C&P20A head
Installing the head adapter for CPP and C&P20A head
Head adapter of the TwinHead
► Loosen all electrical connections. You may want to
mark the position, to make clear assignment easier
later on.
► Loosen the two front screws (1) fastening the HCU in
each case. Make sure that you do not lose the shims.
Make a note of the number of shims used for each
screw, as this may well differ.
► Loosen all the screws (2) fastening the board and
then remove the board.
► Loosen both screws on the bottom side of the base
adapter to disconnect the HCU from the base adapt
-
er.
Fitting and fixing the HCU
► Carefully fit a HCU of the TwinHead onto the base
adapter of the parts set (1).
► Fix the HCU with the four previously removed screws
(2 and 3).
Mounting position for the head adapter
Legend
(1) - (7) Fastening bolts on the mounting position
Installing the CPP Placement Head
Preparing the Head for the Installation Height Assembly of the CPP Placement Head
Assembly Instructions / Montageanleitung Head Reconfiguration Kit CPP 61
Assembly of the CPP Placeme nt Head
3.4 Assembly of the CPP Placement Head
Preparing the Head for the Installation Heigh t
3.4.1 Preparing the Head for the Installation Height
Overview
Head adapter
Legend
(1) – (7) Fastening points on the head adapter
► Place the head adapter onto the fastening bolts in the
mounting position and fasten it with the 7 screws.
► Connect the head interface board via the plug con
-
nector with the head interface.
CAUTION
Installation instructions
► Check the firmware and perform a download, if needed.
CAUTION
The placement head can be installed on two different heights. CPP_L corresponds to a com
-
ponent height of 6 mm. CPP_H corresponds to a component height of 11.5 mm.
If the CPP head is used in a placement area with stationary camera, TwinHead or WPC, it may
only be used in the upper position.
Legend
1. Fixing screws on the left side
2. Fixing screws on the right side
In this graphic the fixing screws are shown in the "head
top" position.
Installing the CPP Placement Head
Assembly of the CPP Placement Head Preparing the Head for the Installation Height
62 Assembly Instructions / Montageanleitung Head Reconfiguration Kit CPP
Conversion to another installation height
(1) Holding bracket (2) "Head bottom" position
(3) "Head top" position (4) Fixture holes with bushings
Legend
1. Drilling for the fixing screw of the bushing in "head
bottom" position
2. Drilling for the fixing screw of the bushing in "head
top" position
3. Bushing
All four bushings and the holding bracket must either be
fixed in top or bottom position.
Proceed as follows when replacing the bushings:
► Undo the fixing screws of the bushings.
► Insert the bushings in the correct position and re-
tighten them.
► Perform these steps for all four bushings and the
holding bracket of the head.