SIPLACE-SX4-DX4-用户手册 - 第222页
Measuring Equipmen t and Tools Setting Gauge for Actuator [03049740-xx] 222 Service Manual SIPLACE SX4/DX4 4.8 4 . 8 S e t t in g G a u g e f o r A c t u a t o r [ 0 3 0 4 9 7 4 0 - x x ] Setting Gauge for Ac tuator [030…
Measuring Equipment and Tools
Compressed Air Testing Device [00311487-01]
Service Manual SIPLACE SX4/DX4 221
4.6
4.6 Compressed Air Testing Device [00311487-01]
Compressed Air Testing Device [00311487-01]
4.7
4.7 Setting Gauge for Board Clamping [00369202-01]
Setting Gauge for Board Clamping [00369202-01]
Use:
The compressed air tester is used to set the air blast at
the C&P6 and C&P12 placement heads in the SIPLACE
placement machines.
Setting gauge for board clamping [00369202-01]
Measuring Equipment and Tools
Setting Gauge for Actuator [03049740-xx]
222 Service Manual SIPLACE SX4/DX4
4.8
4.8 Setting Gauge for Actuator [03049740-xx]
Setting Gauge for Actuator [03049740-xx]
4.9
4.9 Belt Tensioning Device for Turning Station DLM [03063649-01]
Belt Tensioning Device for Turning Station DLM [03063649-01]
1. Setting gauge
2. Terminal strip
This device is used for setting the tension of the toothed
belt at the turning station.
This part is available from introduction of the turning sta-
tion DLM version 06 [00341780-06].
Measuring Equipment and Tools
Programming Cable for PXS240 Sensor [03073330-xx]
Service Manual SIPLACE SX4/DX4 223
4.10
4.10 Programming Cable for PXS240 Sensor [03073330-xx]
Programming Cable for PXS240 Sensor [03073330-xx]
4.11
4.11 Setting Gauge for Sonar Sensors [03048764-xx]
Setting Gauge for Sonar Sensors [03048764-xx]
4.12
4.12 Setting Gauge for Sonar Sensors [03076989-xx]
Setting Gauge for Sonar Sensors [03076989-xx]
Version 1 – UB-PROG4-V31 (old PXS240)
Version 2 – UB-PROG2
Setting gauge for ultrasonic sensors [03048764-xx]
Setting gauge for ultrasonic sensors in X quad lane, X op-
tions, SX series and SX options
Wen you place the gauge on the conveyor, make sure
that the designation for the relevant conveyor remains
visible.
▪ 3mm gap for the X conveyor
▪ 2mm gap for the SX conveyor