Manuelles Tray an D1 an Stellplatz 2 - 第15页
Special Design 2 Assembly instructions Special des ign for manual tray at location 2 SIPLACE D1 05/2007 Edition 15 2 Assembly instructions S pecial design for manual tray at location 2 SIPLACE D1 2.1 W orking principle A…
1 Montageanleitung SOKO Manuelles Tray an Stellplatz 2 SIPLACE D1 SOKO
Ausgabe 05/2007
14
Special Design 2 Assembly instructions Special design for manual tray at location 2 SIPLACE D1
05/2007 Edition
15
2 Assembly instructions
Special design for manual tray at
location 2 SIPLACE D1
2.1 Working principle
At SIPLACE D1 it is possible to place a JEDEC Tray inside the machine. 2
2
2
2.2 Requirements
2
Hardware: SIPLACE D1 - single conveyor
Software: -
2 Assembly instructions Special design for manual tray at location 2 SIPLACE D1 Special Design
05/2007 Edition
16
2.3 Restrictions
The maximum conveyor width is approximately 260 mm. 2
The tray holder is intended solely for components which, including the tray, do not exceed 16 mm
in height. 2
If other components are to be placed in this tray holder, they must not be higher, otherwise there
is a risk of crashing with the placement head. 2
If a service tool is used, the machine must be set up with the standard setup once more. 2
Only a limited performance calculation is possible. 2
2
The restrictions concerning the component range still apply. 2
2
2.4 Scope of delivery
– Tray holder for location 2 (for 1 JEDEC Tray)
– 2 hexagon socket head screws M5 X 30 mm for tray holder
– Fixing bracket for limit switch
– 2 magnets for fixing the tray
– SOKO adhesive label
– Programming guide for arbitrary carrier under SIPLACE Pro (00194607-xx)
– Assembly instructions for tray holder SIPLACE D1 (00195627-xx).
2.5 Tools and consumables required
– Set of hexagon socket spanners
– Set of screw drivers
– Cable ties
– Self-adhesive cable clamps
–Side cutters
– Ethyl alocohol for cleaning
– Lint-free cloths.