Manuelles Tray an D1 an Stellplatz 2 - 第24页
2 Assembly instructions Special design for manual tray at lo cation 2 SIPLACE D1 Special Design 05/2007 Edition 24
Special Design 2 Assembly instructions Special design for manual tray at location 2 SIPLACE D1
05/2007 Edition
23
: Stick the SOKO label on the right cover.
: Check the cable routing from the limit switches.
: Switch on the placement machine and change to the SITEST.
: Adjust both limit switches and test the conveyor width adjustment and the function of the limit
switches.
2.8 Disassembly of the hardware
The disassembly has to be done in reverse direction. 2
2.9 Programming under SIPLACE Pro
2
For programming under SIPLACE Pro, use the instructions „Programming guide for arbitrary car-
rier under SIPLACE Pro“ (item no.: 00194607-xx). 2
2
2.10 Possible causes of error
Pick-up problems 2
– The trays were not fixed using the magnets provided.
Solution: Fix the trays again.
– The trays are not described correctly in SIPLACE Pro.
Solution: Correct the tray description.
– Placement head picks up at a wrong place.
Solution: Determine offset values using the Arbitrary Carrier instructions and enter correct val-
ues.
– The trays have no or wrong offset values.
Solution: Determine the right offset values (see instructions).
– Tray holder was not fitted correctly.
Solution: Tighten all the screws.
– The trays are not fixed without stress using the magnets provided.
Solution: Fix the trays again.
2 Assembly instructions Special design for manual tray at location 2 SIPLACE D1 Special Design
05/2007 Edition
24