CX200-4(Maint) - 第77页
(5 ) Pass the head cleaning paper through the clearance and slide it right and left 10 to 20 times, keeping the effective length of the stoke. Fig. 4A87 (6) Pull out the head cleaning paper such that the folded part (fol…
1.4.8 Cleaning of Linear Scale/Encoder Head
Clean the linear scale and the encoder head every 3 months or after
the linear guide is lubricated to prevent the feeder carriage from mal-
functioning.
Cleaning Procedure
(1) Be sure to turn off the power breaker before cleaning work.
(2) Fold the head cleaning paper as follows.
Fig. 4A85
(3) Wet both surfaces of Sides A and B (head cleaning paper) adequately
with alcohol (absolute ethanol).
(4) Insert the head cleaning paper into the clearance beside the en-
coder head such that Side B (engaged between the upper and lower
claws of the scale holder) faces the encoder side.
Fig. 4A86
01 10-003 1
65 AFO01ETRP
1.4 Maintenance Method
(5) Pass the head cleaning paper through the clearance and slide it
right and left 10 to 20 times, keeping the effective length of the stoke.
Fig. 4A87
(6) Pull out the head cleaning paper such that the folded part (folding
mark) should pass through the clearance between the encoder head
and the scale holder as shown below.
Fig. 4A88
(7) Follow Steps (2) through (6) again, using new head cleaning paper.
(8) After the cleaning, move the feeder carriage sideways and clean
the linear scale with a cotton swab soaked in alcohol (absolute etha-
nol).
(9) Power up the machine and perform “Reference Mark Detection Mode”
to check the feeder carriage movement.
01 10-003 1
66 AFO01ETRP
1.4 Maintenance Method
1.5 Maintenance Check List
This session describes how to perform the maintenance work periodi-
cally.
Use the tables below as check lists.
Refer to “1.3 Maintenance Spots” for the maintenance of each indi-
vidual spots of the machine.
1.5.1 Daily Maintenance
Table 4A20
1.5 Maintenance Check List
01 10-003 1-67 AFO01ETRP
Air Source
Vacuum System
Dust Collector and
Waste Tape Box
Component
Recognition Section
Main Body Section
Intermediate Base/
Component
Receiving Box
Cutter Section
Main Air Pressure
Air Blowing Pressure
Sub Air Pressure
Vacuum Pressure
Waste Tape Box
Ring Lighting
Upper Surface of
Glass
Upper Surface of
Intermediate Base
Component
Receiving Box
Component Drop
Prevention Cover
1D1
1D2
1D3
1D4
1D5
1D6
1D7
1D8
1D9
4A10
Checking
4A11 Checking
4A12 Cleaning
4A13 Cleaning
4A14 Cleaning
4A15 Cleaning
-----
-----
-----
-----
-----
-----
-----
-----
-----
Lens
Cleaning Cloth
Vacuum
Cleaner
Vacuum
Cleaner
Maintenance Spots
Description Grease
Cleaning
tools,
Nozzles, etc.
Check
Name
No.
Fig.
No.