YS24X_Ope_E - 第106页
2-31 2 asic operation 7 Clamp the tape guide assembly . Set the carrier tape so it engages with the teet h on the sprocket. Clamping the tape guide assembly T ape guide assembly T ape guide front lever 23209-L4-00 c …
2-30
2
asic operation
3
Set the tape in the tape feeder.
Insert in the hole on the rear of the feeder.
Mounting the tape
Tape
23207-L4-00
c
4
Peel off the top tape.
The tape consists of 2 layers. One is a "carrier tape" holding the electronic component and the other is a
"top tape" covering the upper surface of the component. Peel off the top tape.
5
Set the carrier tape.
Run the carrier tape through the hole in the tape guide front lever.
6
Set the top tape.
Run the top tape through the notch in the tape guide assembly. Be sure to pull out enough tape so the
top tape reaches the take-up roller.
Carrier tape and top tape
Top guide assemblyBottom plateTop tape Carrier tape Tape guide front lever
23208-L4-00
c
2-31
2
asic operation
7
Clamp the tape guide assembly.
Set the carrier tape so it engages with the teeth on the sprocket.
Clamping the tape guide assembly
Tape guide assembly
Tape guide front lever
23209-L4-00
c
guide assembly during clamping.
8
Set the top tape in the take-up roller.
Clamp the section of the take-up roller lever shown in the photo to form a gap in the take-up roller,
insert some of the top tape into that gap, then release the take-up roller lever to grip the top tape.
Setting the top tape
Top tapeTake-up roller
Take-up roller lever Tape guide assembly
23210-L4-00
c
Check that the top tape has not become twisted between the take-up roller and the tape guide assembly.
2-32
2
asic operation
9
Take up any slack in the top tape.
Pull the top tape gently towards the arrow shown in the photo and release to automatically wind the
tape.
Winding the top tape to remove slack
Top tape
23211-L4-00
c
0
Feed the components to the pickup position.
Press the [FEED] button on the feeder body to convey the components to the pickup position. To return
the components to the feeder, press the [BACK] button. The tape feeds 2 millimeters each the button is
pressed.
c
advance the carrier tape.
[FEED] button, [BACK] button, [FUNC] button
[BACK] button
[FEED] button[FUNC] button
23212-L4-00
TIP
• The feed pitch will always be 2 mm each time the [FEED] or [BACK] button on the feeder body is pressed,
regardless of the pitch setting. Holding down either of these buttons feeds the tape continuously.
• Use the [FUNC]+[FEED] buttons to feed the tape at the feed pitch that was set.