YS24X_Ope_E - 第111页
2-36 2 asic operation n Setting a pitch from each station T he following describes the procedure for setting a tape feed pitch using the temporary tape set station or power station for the off-line setup. 1 Check the t…
2-35
2
asic operation
4
Set the tape feed pitch.
From the "Feed Pitch" drop-down list, select the feed pitch that matches the components in the feeder,
and then press the [OK] button.
Setting the tape feed pitch
24221-L4-00
5
Check the tape feed operation.
Press the [Feed] button on the lower right of the screen to check that the tape is fed at the pitch you
set.
Checking the feed pitch
24222-L4-00
2-36
2
asic operation
n
Setting a pitch from each station
The following describes the procedure for setting a tape feed pitch using the temporary tape set station or
power station for the off-line setup.
1
Check the tape feed pitch of the feeder.
The tape feed pitch is indicated on the display as shown below.
Checking the tape feed pitch
Display
23213-L4-00
2
Set the tape feed pitch.
Press the [UP] or [DOWN] button to set the feed pitch that matches the components in the feeder, and
then press the [SET] button to determine the setting.
Setting the tape feed pitch
[SET][UP] [DOWN]
23214-L4-00
2-37
2
asic operation
3
Check the tape feed operation.
Press the [FEED] button on the feeder body to check that the tape is fed at the correct pitch.
c
advance the carrier tape.
TIP
• The feed pitch will always be 2 mm each time the [FEED] or [BACK] button on the feeder body is pressed,
regardless of the pitch setting. Holding down either of these buttons feeds the tape continuously.
• Use the [FUNC]+[FEED] buttons to feed the tape at the feed pitch that was set.
Checking the feed pitch
[BACK] button
[FEED] button[FUNC] button
23215-L4-00