YS24X_Ope_E - 第115页
2-40 2 asic operation 3 Install the slope plate on the feeder . Insert the knock-pin of the slope plate to the u pper plate and secure two positions with the slope plate securing screws. Installation of the slope plate…
2-39
2
asic operation
4.2 Wide multi-stick feeder
4.2.1 Installation of tracks and sticks
1
Install the tracks on the slope plate.
Place the tracks of the right width for the sticks you desire to use on the slope plate and secure them
with screws.
If the height of the tracks is lower than that of the slope plate, fit the spacers (provided with unit)
between the tracks and slope plate so that the pickup height will be the same.
n
NOTE
For detailed information on the pick height and stick height, refer to the User’s Manual for SS feeder.
Installation of the tracks
Slope plate
Spacer
Track
Stick restraint
23217-L4-00
c
as collision with the head.
2
Adjust the stopper position.
The line shown in the illustration below is the component pickup point.
Loosen the screws on the back of the tracks and adjust the stoppers to match the pickup point and the
center of the component.
Pickup point
Pickup point
Line
Stopper
Pickup
point
23218-L4-00
c
Use supply components of 36 mm or less in length. Components longer than 36 mm cannot be supplied when the
feeder operates.
2-40
2
asic operation
3
Install the slope plate on the feeder.
Insert the knock-pin of the slope plate to the upper plate and secure two positions with the slope plate
securing screws.
Installation of the slope plate
Slope plate
Knock-pin
Slope plate securing
screw
Slope plate securing
screw
Upper plate
Feeder
23220-L4-00
4
Remove rubber pieces from sticks.
Rubber pieces are attached to the both ends of stick-type components to maintain electronic
components in place. Remove these rubber pieces before use.
c
Handle carefully so that electronic components do not fall out of the sticks.
5
Insert the sticks in the tracks.
Pass the stick under the stick restraint as shown in the illustration below to insert the stick to the track.
c
Install the components in the correct direction with the correct side up.
Insertion of the sticks
Stick Restraint A
Stick
Track
23221-L4-00
2-41
2
asic operation
n
If sticks are loose or deflect too much
The flat spring of the stick restraint B should be adjusted.
Loosen the screws securing the flat spring of the stick restraint B and adjust the position of the flat spring so that
appropriate tension is added to the sticks, and tighten the screws.
Stick restraint
Stick support
Stick restraint B
23222-L4-00
n
If sticks are too short to reach the stick support
Raise the adjustment plate as shown in the illustration below to support the stick from below.
Adjustment plate
Stick
Adjustment plate
23223-L4-00