YS24X_Ope_E - 第118页
2-43 2 asic operation 4.3 T ray changer (sA TS II ) n Precautions when handling pallets and magazines Observe the following points w hen handling pallets and magazines. • Store pallets and magazines in a clean environm…
2-42
2
asic operation
4.2.2 Installation on a mounter
Observe the following instructions for installing the wide multi-stick feeder on a mounter.
e
1
Install the tracks on the slope plate.
Press the emergency stop button on the mounter to stop mounter operation.
c
2
Clean the surface of the feeder bank.
Parts or debris caught in the machine will tilt the feeder, interfering with stable pickup.
3
Set the feeder.
Raise the clamping lever, align the target mark to the feeder installation position and slide it to insert it
to the location pin hole.
Attachment of the feeder
Clamping lever
Connector for power/signal
Location pin
Tail pin
Target mark
Handle part
23224-L4-00
4
Check the assembled condition.
Release the clamping lever and try to move the feeder back and forth to check if it is fixed securely.
5
Set components.
Press the [FEED] button so that the first component reaches the pickup position. The feeder will vibrate
for two seconds to feed components at the touch of the button.
Confirmation of operation and setting components
First component
Stick
[FEED] button
23225-L4-00
TIP
For detailed information on the wide multi-stick feeder, refer to the User’s Manual for SS feeder.
2-43
2
asic operation
4.3 Tray changer (sATS
II
)
n
Precautions when handling pallets and magazines
Observe the following points when handling pallets and magazines.
• Store pallets and magazines in a clean environment where dust, grime and oil will not adhere.
• Take care not to drop pallets and magazines or apply excessive force or impacts. If a pallet or magazine is warped or
deformed by, for example, dropping, do not use it.
• Avoid hurting yourself on the edges of the pallets or magazines.
• When carrying a magazine, use the handles on the upper right/left of the magazine and do not let the magazine tilt.
• Carry the magazine with the pallet retainer rod affixed at top and bottom as shown in photo A. This will prevent the
pallets stored in the magazine from slipping out while being carried.
• When setting the magazine in the sATS
II
magazine rack, pull the pallet retainer rod upwards and then fold it on the
upper surface as shown in photo B. Also be sure to always fold the left and right handles down on the top section.
Photo A
Grip as shown when carrying a magazine
Handles
Fit the pallet retainer rod on at top and bottom.
23227-L4-00
Photo B
When setting a magazine in the rack
Fold down the handles.
Pull the pallet retainer rod upwards and then fold it down on the top surface.
23228-L4-00
2-44
2
asic operation
4.3.1 Setting the component trays in the pallet
Several component trays can be set on one pallet (depending on the size of trays). Set the trays as described
below.
1
Remove the tray clamp magnets.
2
Set the component tray on the pallet.
Set so the corner of the component tray is aligned with the pallet reference position (pallet origin point).
After setting the tray, clamp it in place with the magnets.
Clamping the component tray
Using one tray
Using several trays
Tray pitch X
Clamping magnet
Clamping magnet
Tray
Tray pitch Y
Tray reference position
(pallet origin position)
23229-L4-00
3
Check that the component tray is clamped.
Press only on the tray to make sure it is securely clamped by the magnet.