00198505-01_SM_SIPLACE_SmartFeeder_EN - 第112页
7 Repairs to SmartFeeder 8 mm X 7.10 Tamp wheel 112 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 7.10.1 Removing the tamp wheel ► Carefully place the feeder module with the right side down on a stable, level a…
7 Repairs to SmartFeeder 8 mm X
7.10 Tamp wheel
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 111
► Press the rocker into the spring (4).
► Move the rocker until you can completely see the
drilled hole for the rocker holder through the
drilled hole for the rocker itself(3).
► Push the bearing shaft(5) into the drilled hole,
with the thread first.
► Fasten the bearing shaft hand-tight with a size 1
slotted screwdriver.
7.10 Tamp wheel
Required spare part
Fig.34: Knurled tamp wheel assy.
Feeder module Item no. Designation
SmartFeeder 8mm X 03102274-xx Knurled tamp wheel assy. X8Smart
Required tools
●
Phillips screwdriver, small
●
Flat-bladed screwdriver
●
Allen key size 4
●
Tweezers
7 Repairs to SmartFeeder 8 mm X
7.10 Tamp wheel
112 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
7.10.1 Removing the tamp wheel
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Remove the left side cover (see 7.3.1 "Removing
the Left Side Cover" [}83]).
► Remove the 3 Phillips screws(1) marked in the
diagram from the bearing cap for the foil drive.
► Lift the bearing cap(2) up with a pair of tweezers
or a small screwdriver(3) and remove it.
► Remove the rocker (see 7.9.1 "Removing the
rocker assembly " [}110]).
► Remove the wiper. (see 7.11.1 "Removing the
wiper 8 mm X " [}117])..
► Loosen the Allen bolt on the spiral gear.
Use a size 4 Allen key for this.
7 Repairs to SmartFeeder 8 mm X
7.10 Tamp wheel
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 113
► Tilt the feeder module to the right and hold the Al-
len screw on the spiral gear with one finger.
► Remove the slotted screw.
► Remove the spiral gear.
► Remove the top washer from the spiral gear.