00198505-01_SM_SIPLACE_SmartFeeder_EN - 第113页
7 Repairs to SmartFeeder 8 mm X 7.10 Tamp wheel Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 113 ► Tilt the feeder module to the right and hold the Al- len screw on the spiral gear with one finger. ► Remove th…
7 Repairs to SmartFeeder 8 mm X
7.10 Tamp wheel
112 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
7.10.1 Removing the tamp wheel
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Remove the left side cover (see 7.3.1 "Removing
the Left Side Cover" [}83]).
► Remove the 3 Phillips screws(1) marked in the
diagram from the bearing cap for the foil drive.
► Lift the bearing cap(2) up with a pair of tweezers
or a small screwdriver(3) and remove it.
► Remove the rocker (see 7.9.1 "Removing the
rocker assembly " [}110]).
► Remove the wiper. (see 7.11.1 "Removing the
wiper 8 mm X " [}117])..
► Loosen the Allen bolt on the spiral gear.
Use a size 4 Allen key for this.
7 Repairs to SmartFeeder 8 mm X
7.10 Tamp wheel
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 113
► Tilt the feeder module to the right and hold the Al-
len screw on the spiral gear with one finger.
► Remove the slotted screw.
► Remove the spiral gear.
► Remove the top washer from the spiral gear.
7 Repairs to SmartFeeder 8 mm X
7.10 Tamp wheel
114 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Remove the tamp wheel.
► If the bottom washer is still stuck to the spiral
gear, take it and place it back on the axis.
7.10.2 Fitting the tamp wheel
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Make sure that there is a washer on the axis.