00198505-01_SM_SIPLACE_SmartFeeder_EN.pdf - 第128页
7 Repairs to SmartFeeder 8 mm X 7.15 Control board 128 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 7.15 Control board CAUTION Electrostatic charge When removing and fitting the control board, observe the curr…
7 Repairs to SmartFeeder 8 mm X
7.14 Handle with control panel
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 127
► Push one end of the pressure spring in the
handle, as shown.(1)
► Insert the slide into the other end of the pressure
spring.(2)
► Press the slide into the pressure spring and insert
it from above, into the handle.(3)
At this point, the cover on the foil stuffing unit will be accessible and can be replaced if necessary,
before you fit the operating panel.
► Fasten the operating panel (see 7.14.1.2 "Fitting the Control Panel and Board" [}123]).
► Fasten the left side cover (see 7.3.2 "Fitting the left side cover" [}83]).
7 Repairs to SmartFeeder 8 mm X
7.15 Control board
128 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
7.15 Control board
CAUTION
Electrostatic charge
When removing and fitting the control board, observe the currently applicable ESD
guidelines.
Required spare part
Fig.40: Control board X8Smart V2
Feeder module Item no. Designation
SmartFeeder 8mmX (V1)
00141370-01
03101127-xx Control board X8Smart
SmartFeeder 8mmX (V2)
00141370-02
03124276-xx Control board X8Smart V2
SmartFeeder 8mm X splice sensor (V1)
00141390-01
03101127-xx Control board X8Smart
SmartFeeder 8mm X splice sensor (V2)
00141390-02
03124276-xx Control board X8Smart V2
Required tools
●
Phillips screwdriver 0.9Nm
●
TORX screwdriver 0.6Nm and 0.2 Nm, size T8
7 Repairs to SmartFeeder 8 mm X
7.15 Control board
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 129
7.15.1 Removing the control board
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Remove the three Phillips screws marked in the
picture(1), which fasten the control board to the
right side cover.
► Carefully remove the TORX screw shown in the
diagram(2), which fastens the EDIF connector to
the control board.
Use a size 8 TORX screwdriver for this.
► Carefully place the feeder module with the right
side down on a stable, level and clean surface.
► Remove the left side cover (see section 7.3.1
"Removing the Left Side Cover" [}83]).
► Remove the EDIF connector.(1)
► Loosen the 6 connections shown in the dia-
gram.(2 – 7)
► If there is a splice sensor fitted in the feeder mod-
ule, open the connection to the splice sensor
cable.(1)
► Remove the control board.