00198505-01_SM_SIPLACE_SmartFeeder_EN - 第219页
9 Repairs to SmartFeeder 12 mm X / 16 mm X 9.10 Tape Disposal Flap Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 219 9.9.2.2 Fitting the Rocker Stripping Device ► Position the stripping device sideways (as show…
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.9 Rocker
218 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
9.9.2 Rocker Stripping Device
Required spare part
Fig.78: Wiper for rocker X12/X16 V2
Feeder module Item no. Designation
SmartFeeder 12mm X
SmartFeeder 16mm X
03081908Sxx Wiper for rocker X12/X16 V2
Required tools
●
TORX screwdriver size T8, 0.6Nm
9.9.2.1 Removing the Rocker Stripping Device
► Remove the rocker (see 9.9.1.1 "Removing the
Rocker Assembly" [}216]).
► Remove the two screws shown.(1)
Use a size T8 TORX screwdriver for this.
► Pull the stripping device off towards the front.
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.10 Tape Disposal Flap
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 219
9.9.2.2 Fitting the Rocker Stripping Device
► Position the stripping device sideways (as
shown) over the tamp wheel and into the
rocker.(1)
► Align the stripping device straight and fasten it
using the top (2) and bottom (3) screw with
0.6Nm.
► Make sure that the tamp wheel can be turned
easily and only in the direction shown.
If this is not the case, loosen both screws, adjust
the stripping device and tighten the screws again.
► Reinsert the rocker (see 9.9.1.2 "Fitting the
Rocker" [}217]).
9.10 Tape Disposal Flap
Required spare part
Fig.79: Foil disposal flap
Feeder module Item no. Designation
SmartFeeder 12mm X 03081997Sxx Tape disposal flap X12 V2
SmartFeeder 16mm X 03091584- xx Tape disposal flap X16 N assembly
Required tools
●
Allen key size 3, 0.6Nm
9 Repairs to SmartFeeder 12 mm X / 16 mm X
9.10 Tape Disposal Flap
220 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
9.10.1 Removing the Flap
► Carefully place the feeder module with the left-
hand side down on a stable, level and clean sur-
face.
► Remove the screwed axle on the flap(1). Use a
size 3 Allen key for this.
► Remove the flap sideways from the feeder mod-
ule.(2)
9.10.2 Fitting the Flap
► Carefully place the feeder module with the left-
hand side down on a stable, level and clean sur-
face.
► Push the flap, as shown, side ways into the
feeder module.(1)
► Close the flap.
► Fasten the flap with the screwed axle(2). Use a
size 3 Allen key with 0.6Nm for this.