00198505-01_SM_SIPLACE_SmartFeeder_EN - 第240页
10 Repairs to SmartFeeder 24 - 104 mm X 10.5 Pickup window 240 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 ► Guide the bracket, located at the front left on the pickup window, into the recess on the base unit…
10 Repairs to SmartFeeder 24 - 104 mm X
10.5 Pickup window
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 239
Underneath the pickup window, you will find the
"Ejector X24-104 Smart" [03126631-xx]. This can now
be replaced if needed.
The ejector is fixed with a "collar screw" [03020727-xx]
to the base unit.
10.5.2 Fitting the pickup window
► Before fitting the pickup window, make sure that
the ejector is fitted with a "collar screw".
► Insert the pressure spring(1) into the hole.
► Insert the screw as shown into the holding plate
and then insert the holding plate(2).
10 Repairs to SmartFeeder 24 - 104 mm X
10.5 Pickup window
240 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Guide the bracket, located at the front left on the
pickup window, into the recess on the base unit.
► Position the pickup window as shown, diagonally
onto the base unit from above and lower it down,
towards the back.
► Screw the holding plate tight.
Make sure that the pressure spring is pressed
into the drilled hole while you screw it in.
► Fasten the pickup window with the two screws at
the rear pivot point.(1)
► Fasten the pickup window guiding screw at the
front right.(2)
10 Repairs to SmartFeeder 24 - 104 mm X
10.6 Splice sensor
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 241
10.5.3 Replacing the Öffner pickup window
The opener for the pickup window is fitted with a M2.5
x 5mm Phillips screw and washer to the base unit.(1)
The screw is for loosening and fastening and can be
accessed via a hole on the left side of the tape
duct.(2)
10.6 Splice sensor
Required spare part
Fig.87: Splice sensor (left) / dummy splice sensor (right)
Feeder module Item no. Designation
SmartFeeder 24 - 104mmX 03107028 -xx
03104558 -xx
Splice sensor X8Smart assembly
Dummy splice sensor X8Smart
Required tools
●
TORX screwdriver 0.6Nm, size T8