00198505-01_SM_SIPLACE_SmartFeeder_EN - 第262页
10 Repairs to SmartFeeder 24 - 104 mm X 10.8 Foil rocker 262 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 ► Use a T8 TORX screwdriver to remove the two screws shown in the diagram, which fasten the foil rocker…
10 Repairs to SmartFeeder 24 - 104 mm X
10.8 Foil rocker
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 261
► Press the foil rocker slightly down, to give access
to the hole for the threaded axis.
► Insert the threaded axis as far as the stop into the
hole.
► Fasten the threaded axis with a flat-bladed
screwdriver and 0.6 Nm.
10.8.1.2 Light barrier transmitter
Required spare part
Fig.95: Light barrier transmitter
Feeder module Item no. Designation
SmartFeeder 24 - 104mmX 03100381- xx Light barrier transmitter flat assy. X8Smart
Required tools
●
TORX screwdriver 0.6Nm, size T8
Removing the light barrier transmitter
► Remove the left side plate (see 10.3.1 "Remov-
ing/fitting the left side plate" [}230]).
► Remove the foil rocker (see 10.8.1.1.1 "Remov-
ing the foil rocker" [}260]LINK).
► Swing the holder on the flat ribbon connection X5
of the control board up and pull out the flat-ribbon
cable. (1).
► Pull the flat ribbon cable off the double-sided ad-
hesive tape at the marked point. (2)
10 Repairs to SmartFeeder 24 - 104 mm X
10.8 Foil rocker
262 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
► Use a T8 TORX screwdriver to remove the two
screws shown in the diagram, which fasten the
foil rocker housing.
Make sure that the two spring washers DIN 127-
B2.5-A2 are not lost.
► Pull the foil rocker housing with the flat ribbon
cable up and off the base unit.
► Turn the foil rocker housing into the position
shown.
► Swing the holder on the flat ribbon connection
up.(1)
► Pull the flat ribbon cable out.(2)
► Use a T8 TORX screwdriver to remove the screw
marked in the diagram, which fastens the light
barrier transmitter to the foil rocker housing.
► Remove the light barrier transmitter.
10 Repairs to SmartFeeder 24 - 104 mm X
10.8 Foil rocker
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 263
Fitting the light barrier transmitter cable
► Insert the light barrier transmitter, as shown, into
the foil rocker housing.
Make sure that the locating pins from the foil
housing engage n the two holes on the short
sides of the board.
► Fasten the light barrier transmitter with a T8
TORX screwdriver to the foil rocker housing.
► Swing the holder on the flat ribbon connection
up.(1)
► Push the cable with the blue side pointing up-
wards, into the flat ribbon cable connection, as
far as the stop. (2)Make sure that the cable con-
tacts lie against the contacts on the connection.
► Swing the bracket on the flat ribbon connection
down.(3)
► Position the foil rocker housing from above onto
the base unit.
► Fasten the foil rocker housing with the two
screws shown in the diagram. Use a size T8
TORX screwdriver with 0.6 Nm. for this.