00198505-01_SM_SIPLACE_SmartFeeder_EN - 第27页
6 Repairs to SmartFeeder 4 mm X 6.1 Front sliding guide/sliding foil Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 27 6 Repairs to SmartFeeder 4 mm X Feeder module Item no. Description SmartFeeder 4mmX 001413…
5 Diagnosis and Solutions
5.1 Assignment of Symptoms/Repairs
26 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
Rocker
The rocker is bent.
The plain tamp wheel for the rocker has jammed.
The thread of the bearing shaft is worn.
Replace the rocker assembly
The plain tamp wheel for the rocker is worn or dam-
aged.
Replace the plain tamp wheel
The bearing shaft of the rocker is rough-running or
damaged.
The slit in the bearing shaft is damaged.
Replace the rocker bearing shaft.
Control panel
The display window, an LED lamp or a button is de-
fective.
The removal handle is defective or does not engage
properly.
Replace the operating panel assembly
Leaf spring
The leaf spring on the tape inlet is missing or bent. Replace the leaf spring
6 Repairs to SmartFeeder 4 mm X
6.1 Front sliding guide/sliding foil
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 27
6 Repairs to SmartFeeder 4 mm X
Feeder module Item no. Description
SmartFeeder 4mmX 00141368-xx SIPLACE SmartFeeder 4mm X
6.1 Front sliding guide/sliding foil
Required spare part
Fig.2: Sliding foil
Feeder module Item no. Designation
SmartFeeder 4mmX 03019604Sxx Sliding foil, X-feeder JUM-S-06LY
Required tools
●
Sliding foil remover [03075421-xx]
6.1.1 Removing the Sliding Foil
► Place the feeder module carefully down on its
side, onto a stable, level and clean surface.
► Place the sliding foil remover into the sliding
guide, as shown in the diagram.
► Lever the sliding foil out of the engaged position.
► Pull the sliding foil out of the sliding guide, to-
wards the front.
6 Repairs to SmartFeeder 4 mm X
6.2 Rear Sliding Guide
28 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
6.1.2 Fitting the Sliding Foil
► Press the sliding foil slightly together.
► Push the sliding foil into the sliding guide, from
the front, as far as the end stop.
► Turn the sliding foil, until the slit can be fully seen
and the sliding foil engages audibly.
6.2 Rear Sliding Guide
Required spare part
Fig.3: Sliding guide, back
Feeder module Item no. Designation
SmartFeeder 4mmX 03003994- xx
03158711-xx
03010209-xx
Sliding guide / back L200
Fillister head self-tapping screw DIN7981 2.9x9.5
(3x)
ISO 7045 - M2.5 x 6-A2-50-H (1x)
Required tools
●
Phillips screwdriver 0.6Nm (for 4mmX)