00198505-01_SM_SIPLACE_SmartFeeder_EN - 第39页
6 Repairs to SmartFeeder 4 mm X 6.5 Pickup window Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 39 ► Carefully guide the pickup window (1) over the pin wheel (3) and over the right edge (4) of the feeder module…
6 Repairs to SmartFeeder 4 mm X
6.5 Pickup window
38 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
6.5.1 Removing the Pickup Window
► Carefully place the feeder module with the left
side down on a stable, level and clean surface.
► Remove the two Phillips screws (1).
► Make sure that the counterplate(2) does not fall
out.
► Make sure that the pressure springs(3) do not
fall out.
► Move the feeder module to an upright and stable
position.
► Carefully pull the pickup window upwards, over
the pin wheel and away to the left.
6.5.2 Fitting the Pickup Window
► Move the feeder module to an upright and stable
position.
► Guide the pickup window (1) with the two bolts
(2) into the feedthroughs provided for the feeder
module drive.
6 Repairs to SmartFeeder 4 mm X
6.5 Pickup window
Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017 39
► Carefully guide the pickup window (1) over the
pin wheel (3) and over the right edge (4) of the
feeder module.
► Make sure that, in the marked area, the actu-
ator(5) for the pickup window and the counter-
plate(6) lie flat against the wall of the feeder
module and can be moved up and down.
► Take care when you insert the counterplate that
the springs(7) are completely as shown within
their guidance and that the counterplate can be
inserted neatly.
► Fasten the pickup window (hand-tight) with the
two screws(8) marked in the diagram.
Use a Phillips screwdriver and 0.6Nm.
6 Repairs to SmartFeeder 4 mm X
6.5 Pickup window
40 Service Manual SIPLACE SmartFeeder 4 - 104 mm X 11/2017
6.5.3 Removing the actuator
► Remove the pickup window 6.5.1 "Removing the
Pickup Window" [}38]).
► Remove the fitting screw shown in the diagram.
Use a 1.5mm Allen key.
► Pull the actuator on the righthand side of the
feeder module out of the base unit.
6.5.4 Fitting the actuator
► Push the actuator on the righthand side of the
feeder module into the base unit as shown.
During this, push the actuator axis into the hole
shown in the diagram.