MV-9_Chapter 5. Teaching.pdf - 第281页
错误 ! 使用“开始” 选项卡将 제목 2 应用于要在此处显示的文字。 错误 ! 使用“开始”选项卡将 제목 2 应用 于要在此处显示的 文字。 . 5- 281 68 If “Reset” button is clicked, the Bar No. increa ses auto m atically a nd the LED Posi tio n i s initialized. 69 Create 3D BLU W indow …
MV-9 User Manual
5-280
- After selecting the added BLU window (part), if „End LED‟ is clicked, the coordinate
of LED Center is calculated through the 3D measurement.
63 Example)
64 Automatic Creation of 3D BLU Window
65 After setting the positions of „Start LED‟ and „End LED‟, if “RUN” is clicked, the window is
automatically created.
66 If the window creation is completed, “Complete Creation of LEDs & Setting Center”
message is output.
67 Teach the entire bars in the same way..
Bar Start LED
Bar End LED
错误!使用“开始”选项卡将 제목 2 应用于要在此处显示的文字。错误!使用“开始”选项卡将 제목 2 应用
于要在此处显示的文字。 .
5-281
68 If “Reset” button is clicked, the Bar No. increases automatically and the LED Position is
initialized.
69 Create 3D BLU Window (part) for all the bars by repeating processes ③ through ⑤.
70 “Auto Frame Generation”
- Select “Auto Frame Generation” by clicking the right mouse button on the full image
window.
- The created 3D BLU Window (part) is automatically taught to all LED‟s while displayed.
MV-9 User Manual
5-282
71 Setting of Reference Center Point for LED PKG during Automatic Teaching.
- The Reference Center Point of LED PKG is set during the automatic teaching.
- In case of not using the Marker, use the reference center point generated during the
automatic teaching.
- The reference center point generated during the automatic teaching is marked by a red
circle. (Do not mark in case of using the Marker.).
- In case of not using the Marker, no compensation is made for Bar Bending, which may
cause pseudo poor quality.
5.10 Height Checker
The objective is to inspect the height difference from the reference position.
5.10.1 Selection of Window for Height Inspection
With window button, select the height inspection window and add the window to the inspection
position and the reference position.( ).
5.10.2 Projector Selection
Select the projector to be used in the inspection.
- It is possible to select the east, west, south or north projector. Select the east and
south projector by default.