4OM-1050-002 - 第101页
1.4.10 Cleaning of Linear Motor's Y oke Sides Clean the yoke sides of the linear motors every month. • Work Procedure (1) T urn off the power switch of the machine and the air source. (2) Open all the feeder work ar…
1.4 Maintenance Method
(3) Press the [ON] button entitled "MOVE". In 2 seconds, press the [EN-
ABLE] button on the operation panel.
The feeder carriage moves to the F1 side and the following sheet
appears.
Fig. 4A91
(4) Press the [Next] button.
(5) Repeat the same steps and confirm that the reference mark can be
detected.
0307-002 1-84 AFO01ETRP
1.4.10 Cleaning of Linear Motor's Yoke Sides
Clean the yoke sides of the linear motors every month.
• Work Procedure
(1) Turn off the power switch of the machine and the air source.
(2) Open all the feeder work area safety doors.
(3) Clean the top and bottom sides of the upper yoke and the top side of
the lower yoke with a rag.
Fig. 4A92
(4) Push the feeder carriage by hand to move it sideways.
(5) Clean the top and bottom sides of the upper yoke and the top side of
the lower yoke with a vacuum cleaner or a rag.
1.4 Maintenance Method
• Do not bring any metal of high magnetizability close
to this. Otherwise, such metal will easily be magne-
tized and attracted, causing an injury to the operator
and/or a mechanical breakdown.
• Do not bring any magnetizable material close to this.
Those who wear implanted pacemakers should not
work inside the machine. Otherwise, the pacemaker
may be affected by magnetism, leading to a serious
accident.
CAUTION
WARNING
0307-001 1-84-1 AFO01ETRP
Feeder Carriage
Bottom Side of Upper Yoke
Top Side of Lower Yoke
Top side of Upper Yoke
Upper Surface of
Intermediate Base
1.5 Maintenance Check List
This session describes how to perform the maintenance work periodi-
cally.
Use the tables below as check lists.
Refer to "1.3 Maintenance Spots" for the maintenance of each indi-
vidual spots of the machine.
1.5.1 Daily Maintenance
Table 4A20
1.5 Maintenance Check List
0307-002 1-85 AFO01ETRP
Air Source
Vacuum System
Dust Collector and
Waste Tape Box
Component
Recognition Section
Main Body Section
Intermediate Base/
Component
Receiving Box
Cutter Section
Main Air Pressure
Air Blowing Pressure
Sub Air Pressure
Vacuum Pressure
Waste Tape Box
Ring Lighting
Upper Surface of
Glass
Component
Receiving Box
Component Drop
Prevention Cover
1D1
1D2
1D3
1D4
1D5
1D6
1D7
1D8
1D9
4A10 Checking
4A11 Checking
4A12 Cleaning
4A13 Cleaning
4A14
Cleaning
4A15 Cleaning
-----
-----
-----
-----
-----
-----
-----
-----
-----
Lens
Cleaning Cloth
Vacuum
Cleaner
Vacuum
Cleaner
Maintenance Spots
Description Grease
Cleaning
tools,
Nozzles, etc.
Check
Name
No.
Fig.
No.
4A14
-1