4OM-1050-002 - 第84页

1.4 Maintenance Method 0307-007 1-68 AFO01ETRP • • • • • Lubrication Procedure The linear guide in the feeder carriage section must be lubricated with the [POWER ON] button on the operation panel being pressed ("ON&…

1.4 Maintenance Method

0307-005 1-67 AFO01ETRP

1.4.8 Lubrication of Linear Guide in Feeder Carriage Section

Grease should be applied every 6 months after the initial month.

••

• Preparation for Lubrication

(1) Turn off the power supply to the machine and wipe off old grease

on the rail of the linear guide with a rag.

(2) Prepare the FL- and P-type or the U- and P-type attachments.

Fig. 4A84-2

(3) Detach the lubrication covers from the front and rear sides of

the machine.

Fig. 4A84-3 Front Side of Machine

Fig. 4A84-4 Rear Side of Machine

FL Type

P Type

U Type

1.4 Maintenance Method

0307-007 1-68 AFO01ETRP

••

• Lubrication Procedure

The linear guide in the feeder carriage section must

be lubricated with the [POWER ON] button on the

operation panel being pressed ("ON" condition).

It is dangerous. Be sure to lubricate alone (without

any other attended personnel).

(1) Press the [UNIT ADJ.] button on the submenu bar that appears after

the [MAINT.] button is selected.

When the [Oil Supply] tab is pressed in the "Fdr Crg." tab sheet, the

following tab sheet appears.

Fig. 4A84-5 "Oil Supply" Tab Sheet

CAUTION

1.4 Maintenance Method

0307-005 1-69 AFO01ETRP

(2) When the [Start Oil Supply] button is pressed in the "Oil Supply" tab

sheet, the following sheet appears.

Fig. 4A84-6

(3) Press the [ALL] button entitled "ZERO". In 2 seconds, press the

[ENABLE] button on the operation panel. All devices are zeroed.

(4) Press one of the [F1], [F2A], [F3B], [F2B], [F3A] and [F4] buttons

entitled "FEEDER READY".

(5) Press the [ON] button entitled "MOVE". In 2 seconds, press the [EN-

ABLE] button on the operation panel.

All axis automatic tuning takes place and the following sheet ap-

pears. (The feeder carriage moves slightly.)

Fig. 4A84-7