X3_X4_Series machine - 第317页
User manual SIPLAC E X-Series 6 Component han dling Software Version SR.601.xx 11/2005 US Edition 6.4 Used tape channel - CO trolley docking unit, SIPLACE X- series 317 6.4 Used tape channel - CO trolley docking unit, SI…
6 Component handling User manual SIPLACE X-Series
6.3 Used tape chute, SIPLACE X-series Software Version SR.601.xx 11/2005 US Edition
316
6.3 Used tape chute, SIPLACE X-series
6
Fig. 6.3 - 1 Used tape chute for the component trolley docking unit from the SIPLACE X-series
Depending on the PCB conveyor height, the length of the used tape chute can be set so that the
pieces of tape are diverted directly into the reject bin of the component trolley.
PLEASE NOTE 6
The used tape chute for the X-series can only be installed on the component trolley docking unit
for the X-series (see Fig. 5.10 - 3, page 278).
User manual SIPLACE X-Series 6 Component handling
Software Version SR.601.xx 11/2005 US Edition 6.4 Used tape channel - CO trolley docking unit, SIPLACE X-series
317
6.4 Used tape channel - CO trolley docking unit,
SIPLACE X-series
6.4.1 Separating plate for tape pocket heights up to 12 mm
In the standard version, the used tape channel can guide component tapes with a maximum
pocket height of 12 mm to the pneumatic tape cutter.
6
Fig. 6.4 - 1 Used tape chute, SIPLACE X-series
(1) Inlet slot for the used tapes
(2) Outlet slot for the used tape above the pneumatic tape cutter
(3) Dividing plate for tapes < 12 mm (can be removed for tapes > 12 mm)
(4) DIN 93384 screw - M4x20, 2x
6 Component handling User manual SIPLACE X-Series
6.4 Used tape channel - CO trolley docking unit, SIPLACE X-series Software Version SR.601.xx 11/2005 US Edition
318
6.4.2 Removing the separating plate for tape pocket heights > 12 mm
If X feeder modules are used, the component tapes work with a pocket height > 12 mm, so the
separating plate (item 3 in Fig. 6.4 - 1
) must be removed.
WARNING 6
Æ Switch the placement machine off at the main switch to remove the dividing plate.
Æ Disconnect the machine from the power and compressed air supply.
Æ Secure the machine to prevent it being switched on again, as described in section 2.10, page
86
.
Æ Wait until the operating pressure for the tape cutter has dropped to 0 MPa.
Æ Do not reach inside the used tape channel.
Æ Loosen the two hexagon head screws (item 4 in Fig. 6.4 - 1).
Æ Pull out the dividing plate.
PLEASE NOTE
Do not position feeder modules with shallow pockets immediately beside bar feeder modules
with deep pockets. The used tapes could overlap and build up.
6