OM-1646-001_w - 第38页
19 OM-1646 1 1.4 ConrmationofPCBT ransferandPositioning The following describes how to check the status of the PCB transfer and positioning in the "PCB XFER" window (a menu of "AUTO OPN"). Proc…
18
OM-1646
11.3 Collection of PCB Support Pins and Setup Operation of
Conveyor Width
(1) Display the "SPRT-PINS CNVR Set-up" window using the following icon
procedure.
(2) Select the conveyor in the lane where the operation is performed.
F18
(3) Press the [PCB Support Pins Exchange Pos. Movement] button.
After that, press the [START] button on the operation panel in 10 sec.
(The machine retracts the head and maximizes the conveyor width.)
F19
(4) Press the [PCB Support Pins Rem./Atch. Work] button and within 10
seconds, press the [START] button on the operation panel.
(The PCB support pins are arranged onto the positions specied in the
pattern program).
F20
(5) Press the [Product Opn Target Pos.Movement] switch and within 10 seconds,
press the [START] button on the operation panel.
The support pins are moved based on the pattern program where the
conveyor width has been selected.
Graphic
Development
Procedure
1005-001
11.3 Collection of PCB Support Pins and Setup Operation of Conveyor Width
19
OM-1646
11.4 ConrmationofPCBTransferandPositioning
The following describes how to check the status of the PCB transfer and
positioning in the "PCB XFER" window (a menu of "AUTO OPN").
Procedure
(1) Display the "PCB XFER" window using the following icon procedure.
F21
(2) Send the PCB in the lane where the PCB transfer and positioning status are
conrmed with the input machine.
(3) Select a desired block button (expressed graphically) for "PCB LOCATE 1".
In 10 seconds, press the [START] button on the operation panel to transfer
the PCB.
(4) Conrm that the PCB can be transferred normally and move smoothly
without falling down during the transfer.
(5)
Press the [Execute] button (entitled "PCB LOCATE L").
In 10 seconds, press the [START] button on the operation panel.
(The backup base moves up. )
(6) Press the cover lock switch to turn off the lamp.
(The transparent cover is unlocked. )
Graphic
Development
1005-001
11.4ConrmationofPCBTransferandPositioning
20
OM-1646
(7) Open the transparent cover.
CAUTION
The load power to the motors, etc., is turned OFF
but the setup operation must be performed carefully
when you put your hand inside the machine. Avoid
handandngerinjuries.
(8) Slightly push the PCB by nger to conrm that there is no problem in the
location of the support pins.
(9) Close the transparent cover.
(10) Press the cover lock switch to turn on the lamp.
1005-001
11.4ConrmationofPCBTransferandPositioning