MEC-CP842-1.0E.pdf - 第137页

Adjustments >> Station Adjustments MEC-CP842-1.0E 7-1 7. Adjustment s Specialized skills and jigs are requir ed to complet e machine adjustments. Attempting adjustments without these skills and jigs may result in d…

Replacing Consumable Parts >> Replacing the Carrier Clamp/Unclamp Air Cylinder Packings

6-28 MEC-CP842-1.0E

MEMO:

Adjustments >> Station Adjustments

MEC-CP842-1.0E 7-1

7. Adjustments

Specialized skills and jigs are required to complete machine adjustments.

Attempting adjustments without these skills and jigs may result in damage to the

machine, so adjustments should only be performed by people who have received the

appropriate training.

7.1 Station Adjustments

7.1.1 Tape Feed Lever (ST1)

Point

The tape feed lever is the mechanism that advances the parts tape.

The vertical movement of this lever moves the part to the pick-up position. Two sen-

sors are located in order to check if the tape feed lever reaches the advance limit and

retract limit.

Rod Adjustment

1 Set the positioning jig (ADCPJ8020) in the D1 position.

2 Press [Position] - (Position) [D1-axis] - enter [1] - [OK] and the START button to

move the positioning jig to station 1.

3 Press the EMERGENCY STOP button. This turns off the 200V power.

WARNING

• Press EMERGENCY STOP before performing this procedure.

• Exercise extreme caution when working on the machine if the cam

is not at its origin (0 deg.) Spring recoil can rotate the cam inde-

pendently.

Feeder

Advance sensor

Retract sensor

Tape feed lever (on feeder)

Tape feed lever (on machine)

C7SM4002a

Adjustments >> Station Adjustments

7-2 MEC-CP842-1.0E

4 Use the cam handle to rotate the cam to 0°.

5 Switch the I/O (TAPE FEED SOL ON) setting ON.

6 Adjust the rod so that there is 0.5 mm clearance between the top of the position-

ing jig and the roller.

Adjustment rod

Roller

C73M4001b

0.5 mm

Positioning jig

(ADCPJ8020)

Positioning jig (ADCPJ8020)