MEC-CP842-1.0E.pdf - 第220页
Setup >> Electrical Power Supply & Transformer Wiring 9-4 MEC-CP842-1.0E 9.3 Electrical Power Supply & T ransformer Wiring Point W ire the transformer so that its voltage matches the powe r supply voltage. …
Setup >> Connecting the Air Supply
MEC-CP842-1.0E 9-3
9.2 Connecting the Air Supply
Point
Connect the air hose to the machine, and adjust the regulator to the prescribed air
pressure.
Procedure
1 Connect the air hose to the machine’s air inlet located on the front of the
machine.
2 Raise the filter regulator knob to release the lock.
3 Turn the handle to adjust the air pressure until the gauge reads 0.5 MPa (5kgf/
cm2).
Note: A digital pressure gauge is attached to the rear cover.
4 Press the filter regulator knob down to engage the lock.
Note: The air hose is not supplied with the machine.
<CP-842E>
0.5MPa (5kgf/cm )
2
C746M6003
<CP-842ME>
Air inlet
Digital pressure gauge
Air inlet
Digital pressure gauge
30SH ( for 3/8" hose)
20SH ( for 1/4" hose)
40SH ( for 1/2" hose)
Socket
Hose
20PM Plug
Handle
Knob
Setup >> Electrical Power Supply & Transformer Wiring
9-4 MEC-CP842-1.0E
9.3 Electrical Power Supply & Transformer Wiring
Point
Wire the transformer so that its voltage matches the power supply voltage.
Procedure
Connecting the Power Supply
The power capacities are indicated below. Be sure to connect the machine to a power
supply which exceeds this capacity.
•CP-842E :9.5KVA •CP-842ME :9.0KVA
1 Open the main breaker box, then remove the terminal cover.
2 Feed the power cable into the main breaker box from the power cable inlet
located at the top of the main breaker box.
3 Connect the ground cable to the dedicated ground terminal.
4 Connect the 3-phase cable to the main breaker and tighten to the prescribed
torque.
Terminal screw tightening torque: 5.8 N⋅m (58 kgf⋅cm)
Note: Terminal screws should be tightened periodically.
DANGER
Verify that the external power supply is off before performing this
procedure.
Setup >> Electrical Power Supply & Transformer Wiring
MEC-CP842-1.0E 9-5
5 After connecting the cable, secure it with the cable lock nut located at the power
cable inlet.
Cable lock nut tightening torque: 7.5 N⋅m (75 kgf⋅cm)
Power cable
%CDNGNQEMPWV
20mm
/CKPDTGCMGT
RJCUGYKTG
)TQWPFYKTG
C84SET001E