MEC-CP842-1.0E.pdf - 第226页

Setup >> Moving the Mach ine 9-10 MEC-CP842-1.0E 3 Insert the forklift so that its le ft and right forks are the same distance from the machine center . Moreover , the space betw een the le ft and right forks shoul…

Setup >> Moving the Machine

MEC-CP842-1.0E 9-9

9.5 Moving the Machine

9.5.1 Precautions when Moving the Machine

When moving a machine, observe the safety measures described below to avoid acci-

dents.

• All staff involved in the procedure should wear safety shoes and helmets.

• Prepare the transport path in advance, and keep people who are not involved in

the procedure out of the area.

• The machine should be moved only by qualified personnel.

• Before moving the machine, attach the machine brackets (red) which were

attached when the machine was delivered. (Attach the brackets in the pre-

scribed positions.)

• Use a forklift (load capacity of 10 t or higher) that is approved for the weight of

the machine.

Machine weights: CP-842E Approx. 5,850 kg

CP-842ME Approx. 4,880 kg

• Insert the forklift forks at the prescribed positions.

• Use care to avoid bending the leveling bolts.

• If the balance of a lifted machine is unstable, lower the machine immediately.

• Raise and lower the machine slowly to avoid subjecting the machine to shocks.

Transport Procedure

1 Remove all tape feeders, air hoses, and electrical wiring from the machine.

2 Use the machine brackets (red) to secure the XY-table, the in- and out-carriers,

and the D-axes.

Note: If there are no machine brackets available, use rope, etc., to secure the various parts of the

machine to avoid damaging them.

C746M6008

Carrier brackets

Y-axis bracket

X-axis bracket

Setup >> Moving the Machine

9-10 MEC-CP842-1.0E

3 Insert the forklift so that its left and right forks are the same distance from the

machine center. Moreover, the space between the left and right forks should be

set as wide as possible.

Note: The forklift should be operated in accordance with the manual provided by the forklift manu-

facturer.

4 Using the forklift, lift the machine to a height of 30 cm.

5 Transport the machine by forklift to its new location, then lower the machine

slowly onto the leveling sheets or leveling blocks. For details concerning level-

ing sheet or leveling block configurations, refer to 9.1 "Leveling The Machine".

DANGER

Do not attempt any tasks beneath the lifted machine.

C746M600

D-axis bracket

<CP-842ME>

<CP-842E>

C746M6010

Supplementary Information >> Noise Levels

MEC-CP842-1.0E 10-1

10. Supplementary Information

10.1 Noise Levels

The following table shows the measured noise levels for CP-842E during operation.

Note: The noise level of the CP-842ME is lower than that of the CP-842E.

WARNING

Operators should wear ear plugs in operating environments where

noise levels are high enough (80 dBA or more) to cause hearing

damage.

C746MX001

Machine Model

Max. Noise Level (dBA) RemarksMeasurement points (m)

CP-842E

Front side

Rear side 1 ......................76

Front side 2 ......................74

Background

noise

63 dB

Height from floor: 1.2

Distance from machine sides: 1.0