MEC-CP842-1.0E.pdf - 第62页
Maintena nce >> Cleaning 5-2 MEC-CP842-1.0E 5.1.2 W aste T ape Duct (Every 8 Hours) Point Cut waste tape is carried through a duct as shown in the figure be low . If the duct becomes clogged, the clogged waste tape…
Maintenance >> Cleaning
MEC-CP842-1.0E 5-1
5. Maintenance
5.1 Cleaning
5.1.1 Waste Tape Box and Filter (Every 8 Hours)
Point
Waste tape that is cut by the cutter is carried through a duct to the waste tape box.
This box should be emptied after every 8 hours of operation.
Procedure
Open the door, remove the waste tape box, and empty the contents.
When emptying the waste tape box, also check the filter immediately above it. If the
filter is dirty, clean it with a vacuum cleaner.
Note: When cleaning is complete, ensure that the waste tape box and filter are inserted all the way
back to their original positions. Also, ensure that the door is properly closed.
C746M3001
Waste tape box
Filter
Maintenance >> Cleaning
5-2 MEC-CP842-1.0E
5.1.2 Waste Tape Duct (Every 8 Hours)
Point
Cut waste tape is carried through a duct as shown in the figure below. If the duct
becomes clogged, the clogged waste tape may interfere with tape being fed from the
feeder, resulting in tape feed problems and part pick-up errors.
If a tape feed problem occurs during automatic operation, inspect and clean the duct.
Procedure
Press the EMERGENCY STOP button, and then clean the duct with a vacuum
cleaner. Do not use an air blower.
WARNING
Press EMERGENCY STOP before performing this procedure.
C746M3002
Duct
Feeder
Maintenance >> Cleaning
MEC-CP842-1.0E 5-3
5.1.3 Reject Parts Box (Every 8 Hours)
Point
Parts that are rejected during vision processing are discarded to a reject parts box.
After every 8 hours of operation, this box should be removed from the machine and
emptied.
Procedure
While pulling the lever to the left, slide the reject parts box out towards the front of
the machine.
When returning the reject parts box to its position, make sure that the cushion sheet
is in place at the bottom of the box.
WARNING
Press EMERGENCY STOP before performing this procedure.
C746M3003
Lever
Cushion sheet
Reject parts box