MEC-CP842-1.0E.pdf - 第78页
Maintena nce >> Cleaning 5-18 MEC-CP842-1.0E 5.1.16 Cleaning Checklist C746M3T01Ea Check Schedule Cleaning points 1 Every 8 Hours 2 Monthly 3 Every 8 Hours 4 Every 8 Hours 5 Every 8 Hours 6 Every 3 Months 7 Weekly …
Maintenance >> Cleaning
MEC-CP842-1.0E 5-17
5.1.15 Nozzle Filter (Every 3 Months)
Point
The filter inside the shaft becomes dirty during the course of machine operation, and
should be replaced approximately every 3 months. If errors occur frequently for a spe-
cific nozzle, it is probable that the flow of air is being impeded by a dirty filter.
Procedure
1 Squeeze in the levers shown in the figure below, and carefully extract the filter.
Caution:
1. Do not apply excess force to the nozzle shaft.
2. Ensure that the filter is returned to the nozzle with the levers at the bottom.
2 Remove the pin from the filter assembly and replace both the filter and pin.
WARNING
Turn the main power off before performing this procedure.
C746M301
5
Filter Assy
C746M301
4
Pin
Filter
Maintenance >> Cleaning
5-18 MEC-CP842-1.0E
5.1.16 Cleaning Checklist
C746M3T01Ea
CheckScheduleCleaning points
1
Every 8 Hours
2
Monthly
3
Every 8 Hours
4
Every 8 Hours
5
Every 8 Hours
6
Every 3 Months
7
Weekly
8
Weekly
9
Weekly
10
Monthly
Monthly
11
Weekly
12
Monthly
13
14
Monthly
Nozzle Interior
Fluorescent Nozzle Stickers
Waste Tape Box and Filter
Waste Tape Duct
Reject Parts Box
Nozzle Filter
Camera Glass
Filter Regulator
Machine Interior
Tapered Clutch on the Nozzle Indexing Shaft
Part Height Check Sensor Lens
Air Filter
Oil Cooler Air Filter
Carrier Rodless Cylinder
Removing Parts from the Camera Glass
15
Weekly
Maintenance >> Lubrication
MEC-CP842-1.0E 5-19
5.2 Lubrication
5.2.1 Precautions During Lubrication
• Prior to beginning any lubrication, turn the main power off at the breaker.
• Apply an appropriate amount of lubricant. If too much lubricant is applied, it
may splatter and drop on panels inside the machine. Special care should be
taken to keep the camera lens clean because a dirty lens results in poor part
inspection results. Use a lens cleaner to keep the lens clean.
5.2.2 Types of Lubricant
The necessary lubricants have the following characteristics.
Note: Do not mix lubricants.
C746M3T02
Daphne Eponex No. 2
Multemp SRL
AFC Grease
Lithium grease by Idemitsu suited to mid/low speed parts.
Lithium grease by Kyodo Yushi suited to high/mid/low speed parts.
Multemp LRL3
Lithium grease by Kyodo Yushi suited to mid/low speed parts.
High grade synthetic-base grease by THK suited to
high speed parts.
SHC 630
Turbine oil +
NASKALUBE
PAO-base oil by Mobil used for gears and bearings.
A Fuji special blend of oil containing additives for durability.
Characteristics
Type
Daphne
Super Multi Oil 32
High grade synthetic-base oil by Idemitsu used as a multi-purpose
lubricating oil applicable to a wide range of parts that require
lubrication.