2500_Users_Manual - 第321页

ProM aster 25 00 User Manua l B-1 B Firmware Keys and STOP Commands The ProMa ster 2500 i s normally operated in remote mode using the TaskLink software. Some of the firmware key commands listed in this Appendix are act …

Glossary

A-8 ProMaster 2500 User Manual

Wildcard

A global search character used to speed the search for a specific device

name or file name in TaskLink. When entering filenames, a wildcard

represents one or more characters in a filename. For example,

27*.dat

represents both

27512.dat

and

27128.dat

Yield

The percentage of successfully programmed devices.

ProMaster 2500 User Manual B-1

Firmware Keys and STOP

Commands

The ProMaster 2500 is normally operated in remote mode using the

TaskLink software. Some of the firmware key commands listed in this

Appendix are active only while the handler is in local mode. To execute a

firmware key command from one of the handler menus, perform the

following steps:

1. Put the handler into local mode by pressing the

LOWER CASE

keys.

2. Go to the appropriate menu and press the key sequence to access the

display.

3. Enter the new numeric value or answer the prompt from the 2500’s

keyboard and press

START

The 2500 supports a second set of commands known as STOP commands,

because the commands are entered after pressing

STOP

to pause the

2500. These differ from the firmware key commands because they can be

used while processing devices so you do not have to exit the current Task.

Firmware Keys and STOP Commands

B-2 ProMaster 2500 User Manual

Function Keys to Press Description

While in Remote

Mode:

Local mode

LOWER CASE + L

Changes the 2500 from remote mode to local mode.

Select this mode to run operations such as

diagnostics tests and firmware keys.

While in Local Mode:

Remote mode

LOWER CASE + R

Changes the 2500 from local mode to remote mode.

Display intensity

↓ ↑

Adjust the intensity of the display.

From the Main Menu:

Advance label

LOWER CASE + A

Advances the label’s position for application on the

device. The nominal range is 35 to 60.

Restore factory default

parameters

LOWER CASE + D

Sets all handler parameters to their original software

default values. Use lower case “y” to activate this

function.

Remote mode

LOWER CASE + R

Puts the handler in computer remote control mode

(required for operation with TaskLink PC software).

Set time-out delay for

programming module

LOWER CASE + T

Sets a delay between the time a device is inserted into

the programming module and when TaskLink sends

the command to start programming. When you run

the Cycle Parts operation, this command defines the

length of time the device will be held in the

programming module, simulating a device’s being

programmed. Each digit on the display equals 100

milliseconds (default = 2).

Printer type

LOWER CASE + W

Configures the 2500 for thermal or dot matrix printer

operation.

From the File Utilities Menu:

Delete label files

LOWER CASE + A

Deletes all label files stored in the system. A warning

prompt is displayed.

From the Diagnostics/Optic Test Menu:

Adjust ADC Optic

LOWER CASE + A

Adjust the ADC value to 200 using the

↑

and

↓

Reset motor encoder

LOWER CASE + R

Resets the beam traverse motor’s encoder to zero.

Used for motor testing.

Vacuum generator

On/Off

Turns the vacuum generator on and off while you

run the Optics diagnostic test.

Engage programming

module clamp

Engages and disengages the programming module

clamp each time you press

. Optics 22 and 23

should toggle.