2500_Users_Manual - 第44页

ProM aster 25 00 User Manua l 2-1 2 Installation and Setup For Administrators This chapt er describes h ow to insta l l and start the ProM aster 2500 a nd is directed to system admini strators. You should be familiar wit…

Introduction

ProMaster 2500 User Manual 3/97 1-21

ProMaster 2500 User Manual 2-1

Installation and Setup

For Administrators

This chapter describes how to install and start the ProMaster 2500 and is

directed to system administrators. You should be familiar with the

information described in Chapter 1 before performing the operations

described in this chapter. System operators should skip Chapters 2 and 3

and read the daily operating procedures described in Chapter 4.

The procedures in this chapter include connecting the RS-232C cables,

connecting the external air line, installing and starting TaskLink,

installing the periodic system disk updates, and confirming that the

system is communicating and that no errors were detected during the

powerup self-test.

The information in this chapter is organized as follows:

Before You Install ....................................................................................2-2

Unpacking and Inspecting the 2500......................................................2-2

Installing the 2500....................................................................................2-4

Connecting the PC and Installing TaskLink......................................2-16

Turning on the 2500...............................................................................2-18

Adjusting Print Quality and Position.................................................2-22

Updating the 2500..................................................................................2-29

Installation and Setup

2-2 ProMaster 2500 User Manual

Before You Install

Before you install the ProMaster 2500, confirm that you have the

following items ready in the area where it will be operating:

• Room temperature between 50 and 100 degrees F (10 and 38

degrees C).

• Clean, dry, oil-free factory air supply capable of supplying a constant

volume of 1.0 CFM (cubic feet/minute) at 80 PSI (pounds/square

inch) (5.5 Bar at 0.0283 CMM).

• Air filter (rated at 10 microns) and regulator located between your

compressor and the 2500.

• An air line from your filter/regulator with either a female quick

connect or female 1/4-inch NPT adapter to connect to the air line

supplied with the 2500. The 1/4-inch line provided with the system is

approximately 6 feet long. To prevent condensation in the lines, their

combined length should not exceed 10 feet.

Unpacking and Inspecting the 2500

This section describes how to remove the 2500 from its shipping crate and

lists the components that are shipped with the 2500. Follow the steps

below to remove the 2500 from its wooden shipping crate.

Note: Examine the wooden shipping crate for signs of damage before you begin

to unpack the 2500. Two indicators are attached to the outside of the

shipping crate: the drop indicator tells you if the crate was dropped, and

the tilt indicator tells you if the crate was placed on its side. If either is

positive, or if the crate is damaged in any way, contact your shipping

agent and Data I/O Customer Support (refer to the Preface).

Figure 2-1

Connecting the Air Line from the External Source to the 2500

INPUT AIR

LINE (6 ft.)

ADAPTER

MALE QUICK CONNECT

(With female 1/4 NPT)

FEMALE QUICK CONNECT

(Knurled Sleeve)

SOURCE AIR

LINE (4 ft. max)

FILTER/REGULATOR

TO EXTERNAL

AIR SOURCE

10 FT MAX

SUPPLIED BY CUSTOMER DELIVERED WITH PROMASTER

1761-1

2500