SM-131-006.pdf - 第137页
Device Name Chip Mounter Block Name Page No. Unit Name Revision Model Item GXH -1 Chapter 5 Head Section 7. MSB W hole Cleaning and Lubricat ion Procedures • Cleaning and Lubr ication of Nozzle Shaft (18) After supplying…
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model Item GXH-1
Chapter 5 Head Section
7. MSB Whole Cleaning and Lubrication Procedures
(17) After cleaning it, wipe off the left alcohol with a dried rag otherwise, wait for it gets
dried.
Apply 0.03 g in amount (A half of matchstick head per one line as a measurement) of
DAPHNE EPONEX No.1 grease to the retainer with 2 lines wholly. <Fig. E65>
- Do not blow the air from upper and lower side with a air gun to dry off the alcohol
after cleaning.
- Use a bamboo skewer or something tool to apply grease but do not use cotton swabs or
wood stick, etc. that the cotton materials or wood wastes may adhere.
Fig. E65
0605-001
5-35
Apply grease to 2-lines
Head Side View
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model Item GXH-1
Chapter 5 Head Section
7. MSB Whole Cleaning and Lubrication Procedures
• Cleaning and Lubrication of Nozzle Shaft
(18) After supplying kerosene to the ultrasonic cleaner, clean the nozzle shafts for 15minuts
with the ultrasonic cleaner.
Organize the nozzle shafts by aligning them not to be changed the combination with
retainer. And, use exclusive jig not to allow any interferences between nozzle shafts.
(Amount of kerosene: see Fig. E66) * Pay attention not to drop kerosene on the
diffusion plates.
Fig. E66 Jig for exclusive use in Nozzle Shaft Cleaning
In cleaning with a ultrasonic cleaner, we recommend the exclusive jig that can make the
nozzle shafts stand as shown in light Fig. E66.
And, put the mark of the No. on the side of the Jig holes.
0605-001
5-36
Amount of
kerosene
Diffusion
Plate
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model Item GXH-1
Chapter 5 Head Section
7. MSB Whole Cleaning and Lubrication Procedures
(19) After cleaning them, blow the kerosene with an air gun and blow the nozzle shaft inside,
too.
Apply DAPHNE EPONEX No. 1grease to the area (nozzle shaft) shown in Fig. E67
slightly (like thin oil film) by hand and next, apply 0.03 g in amount (approximately a
half of matchstick head per one line) of same grease to the groove to pass the retainer (2
lines).
Fig. E67
(20) After the cleaning and the lubrication are completed, reassemble them regularly as they
were. First, attach the spring to the nozzle shaft but in this case, apply DAPHNE
EPONEX No. 1 grease to the spring edges after cleaning it in advance.
Fig. E68
0605-001
5-37
Groove to pass retainer
Do not apply grease
around here.
Apply grease to 2-places of spring edge sections.