00195605-01 - 第13页
Sleeves 2 Retrofit instructions Sleeves for the component trolleys SIPLACE D1 / D2 / D4 04/2007 Edition 13 2.3 Fitting the sleeves : Dock the relevant co mponent trolley out of the machine. : Remove the t ape reels and t…
2 Retrofit instructions Sleeves for the component trolleys SIPLACE D1 / D2 / D4 Sleeves
04/2007 Edition
12
2.2 Safety instructions
WARNING
The safety instructions from the “Operational safety” chapter of the user manual and servicing in-
structions take precedence over these instructions. 2
The SIPLACE placement machines are supplied with main power voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or other standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the "Lock out and tag out procedure"
section of the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
2
2.2.1 Definitions
2
Please note 2
2
2
2
Sleeves 2 Retrofit instructions Sleeves for the component trolleys SIPLACE D1 / D2 / D4
04/2007 Edition
13
2.3 Fitting the sleeves
: Dock the relevant component trolley out of the machine.
: Remove the tape reels and their carrier from the tape container.
: Remove the bars, the tape reels are seated on (2 screws per bar).
2
: Unscrew the bracket on one end of the bar (1 screw).
2
Bars
Bracket
Bracket
2 Retrofit instructions Sleeves for the component trolleys SIPLACE D1 / D2 / D4 Sleeves
04/2007 Edition
14
: Remove the sleeves from the bars.
2
Keep the detached sleeves separately to do not mix them up with the new ones. 2
2
2
: Push the new sleeves from the retrofit kit (D1 / D2) or the two retrofit kits (D4) onto the bars.
There are long and short sleeves; use the short ones to fill space inbetween.
2
: Screw the brackets to the bars once more.
: Screw the bars to the component trolley.
2
2
2
2
2
2
2
2
2
Sleeves