00195044-16_UM_VisionTeachStation_DE_EN - 第163页
Vision Teach Station User Manual 8 Starting the vision teach station 05/2016 Edition 8.5 Installing the interface cards 163 8.5 Installing the interface cards If an interface card has to be replaced, you will then have t…
8 Starting the vision teach station Vision Teach Station User Manual
8.4 Messages when starting up for the first time after re-installation 05/2016 Edition
162
8.3.6 Camera interface card not detected or driver not installed
In Device Manager on the vision computer (Control Panel System Hardware Device
Manager), check whether the driver for the CAN camera interface card has been installed
correctly. There must be a "Baumer PCI-A14" entry under "Baumer Optronic Interface Cards
Series A".
If you cannot find this entry, look for the "Coprocessor" entry. In this case, you will have to rein-
stall the driver:
Insert the "Software Vision Teach Station" installation CD.
Under Properties Drivers tab, select the "Update drivers" button.
Select "Install from a list or specific location" and enter the following directory of the installation
CD:
\CameraDriver. 8
If the boifcxdrv.sys file is needed, you will find it in the same directory.
If you cannot find the "Coprocessor" entry either, then the camera interface card is defective. 8
8.4 Messages when starting up for the first time after re-installation
After re-installation or when the software is updated, when the application is started for the first
time, it will update the firmware on the camera illumination or camera interface card.
When the "Teach Station" application is started for the first time, this may mean that the following
messages are displayed:
(1) Updating of the firmware for sensor type xx has started. This will take approximately 2
minutes. Please do not interrupt the update. This could damage the camera configuration.
(2) Firmware for the camera interface card was updated. Please shut down the computer, switch
off at the power switch and restart.
Please follow the instructions in the messages.
Vision Teach Station User Manual 8 Starting the vision teach station
05/2016 Edition 8.5 Installing the interface cards
163
8.5 Installing the interface cards
If an interface card has to be replaced, you will then have to install the drivers as follows:
8.5.1 CAN card
When the computer is restarted, Windows indicates that a new hardware component was detec-
ted. Follow the dialog.
If the driver is not automatically detected, follow the instructions in section 8.3.5, page 160.
8.5.2 Camera interface card
When you install the card, remember to plug in the floppy power supply connector again. When
the computer is restarted, Windows indicates that a new hardware component was detected.
Follow the dialog.
If the driver is not automatically detected, insert the "Software Vision Teach Station" installation
CD and enter the path for the boifcxdrv.inf file manually:
\CameraDriver. 8
Reboot the computer after installing the driver.
9 Using the vision teach station on the SIPLACE LAN Vision Teach Station User Manual
9.1 Connecting the computer to the SIPLACE LAN 05/2016 Edition
164
9 Using the vision teach station on the SIPLACE
LAN
From vision teach station version 3.51 onwards, the software is able to access the databases on
other SIPLACE Pro computers. For this to be possible, the computers concerned must be running
SIPLACE Pro 5.0 SP1 or later.
9.1 Connecting the computer to the SIPLACE LAN
Connect the LAN connection on the network card (see Fig. 4.3 - 2, page 117) using a switch on
the SIPLACE LAN. If the computer does not have a separate network card, please read section
9.4, page 166.
9.2 Accessing other SIPLACE Pro computers from the VTS computer
From the "SIPLACE Pro SIPLACE Pro Connection …" menu start the following dialog:
Fig. 9.2 - 1 Dialog: SIPLACE Pro Connection data