00198168-02_Technical_Training_TX-Series_EN - 第51页

5 Placement Heads 5.1 CPP Head Technical Training SIPLACE TX-Series 10/2016 51 5 Placement Heads 5.1 CPP Head 5.1.1 Overview 5.1.1.1 Overview 1. Holding circuit supply, integrated venturi nozzles and valve terminal 2. Z …

100%1 / 266
4 Gantry System
Room for Your Sketches and Notes
50 Technical Training SIPLACE TX-Series 10/2016
5 Placement Heads
5.1 CPP Head
Technical Training SIPLACE TX-Series 10/2016 51
5 Placement Heads
5.1 CPP Head
5.1.1 Overview
5.1.1.1 Overview
1. Holding circuit supply, integrated
venturi nozzles and valve terminal
2. Z Axis with retract unit
3. DP drive with nozzle
4. Star motor (integrated into the head
frame
5. Component camera
Special Features of CPP Head / Benefit for customer
●
3 placement modes possible:
– C&P mode
– P&P mode *
– Mixed mode *
* Note: P&P mode and mixed mode are not supported by TX micron.
●
Larger and higher spectrum for component: 01005 – 50x40mm / up to 11.5mm height.
●
The vacuum holding circuit has independent venturi nozzles for each segment.
●
Each segment has its own motor with incremental measuring system.
●
Light sensor at bottom is integrated into each segment.
●
Digital Pressure Regulator Valve (PRV) enables switching times between vacuum and air
blast faster.
●
The component sensor is more robust. Prisms with mechanical protection.
5 Placement Heads
5.1 CPP Head
52 Technical Training SIPLACE TX-Series 10/2016
5.1.1.2 Technical Data
Component spectrum Component camera
SST30
Stationary camera
SST33
Component camera
SST45
Component range 01005 to
27mmx27mm
0402 to
50mmx40mm
01005 to
15mmx15mm
Component height
(CPP_H)
Max. 8.5 mm C&P mode
Max. 11.5 mm in P&P and mixed mode
Component height
(CPP_L)
Max. 6 mm at max placement performance
Placement accuracy +/- 40 µm (3 sigma) with camera type 30
+/- 34 µm (3 sigma) camera type 33
+/- 15 µm (3 sigma) camera type 45 (only TX2i micron 15 µm)
Programmable set-down
force
1.0 - 10 N
Component weight Max. 4 g in C&P mode, mixed mode
Max. 8 g in P&P mode
Component cameras SST30 (01005 to 27 mm x 27 mm) Standard
SST33 (0402 to 50 mm x 40 mm)
SST45 (01005 to 15mmx15mm)
Note: TX micron has no stationary camera
Nozzle changer NC Base structure CPx / Short
Nozzle types Nozzle types 20xx and 28xx
For full specification refer to the user manual.
Machine Types
Machine X-Series (SW70x) SX Series X-Series S TX- Series
CPP X X X X
Configuration
Low installation height (CPP_L) or high installation height (CPP_H).
Note: High installation height (CPP_H) is not supported by TX2i micron, but supported by TX2
micron without JTF-ML.