00198536-02_AI_Mixed-Mode_TX2iV1_TX2V2_de_en - 第121页
4 Appendix 4.1 Excerpts from the Service Manual Assembly Instructions / Montageanleitung SIPLACE TX2i V1 SIPLACE TX2 V2 Option Mixed-Mode 01/2019 121 4.1.3.2 Installation Positions of COT Insert (Table Positions) Fig.74…
4 Appendix
4.1 Excerpts from the Service Manual
120 Assembly Instructions / Montageanleitung SIPLACE TX2i V1 SIPLACE TX2 V2 Option Mixed-Mode 01/2019
Installation
Fig.72: Trailing unit interface 1 and 2 - connections
► Fit the trailing unit interface and restore the electrical connections.
Fig.73: Fitting the cover
WARNING!
Crash hazard!
Make sure that the cover (1) does not
protrude.
A protruding cover could cause a colli-
sion with the gantry.
.
► Before you fix the cover into place,
push it right to the back.
► First, fix the cover with the outer, then
with the two inner screws.
4 Appendix
4.1 Excerpts from the Service Manual
Assembly Instructions / Montageanleitung SIPLACE TX2i V1 SIPLACE TX2 V2 Option Mixed-Mode 01/2019 121
4.1.3.2 Installation Positions of COT Insert (Table Positions)
Fig.74: Installation positions and examples
1 Innermost position (SIPLACE TX2i V2)
2 Innermost position (SIPLACE TX1/TX2 V2 at location 2)
3 Outermost position (SIPLACE TX1/TX2 V2 at location 1)
4 Appendix
4.1 Excerpts from the Service Manual
122 Assembly Instructions / Montageanleitung SIPLACE TX2i V1 SIPLACE TX2 V2 Option Mixed-Mode 01/2019
4.1.3.3 Replacing the COT‑i
NOTICE
Working on the COT-i without complete removal of this
For some tasks on the COT-i, it may be enough to just pull the COT-i slightly out of the
machine. In this case, follow the procedure for replacement but observe the following
instructions:
► Remove the screws fastening the central unit and the lifting mechanics.
► You don't usually need to disconnect the cable. However, if the cable is too short, un-
plug it.
► Slightly pull the COT-i out of the machine.
WARNING
Heavy machine parts
► Make sure that the COT-i does not fall out of the machine!
Parts
Fig.75: Assemblies
SIPLACE TX2i V2 03136891-xx COTi TX2i V2 (including cutter and waste tape slide)
SIPLACE TX1/TX2 V2 03146501-xx COTi TX V2 (including cutter and waste tape slide)
Equipment and tools
00353832-xx Allen key set
Wire cutters
Cable ties
Suitable lifting device (e.g. hand-operated crane)